Best Answer

Part can be bought from the part store for about $150. I found the part on e-bay new for about $50. I would imagine a dealership would charge close to $300 or better repair.

User Avatar

Wiki User

โˆ™ 2007-11-17 23:07:07
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How much should it cost to repair an ignition coil assembly in a 99 VW beetle?
Write your answer...
Related questions

How to remove ignition barrel 1971 volkswagen beetle?

You should buy the Bentley manual as the ignition switches have changed over the years.

Do you need to change the key chip if you change the ignition switch in a terrano?

The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.

How do you repair fuel filler door new beetle?

A quick fix for a fuel filler door on a new Beetle automobile is to use a paperclip where the hinge should be. If the door is completely broken off, a new door should be purchased.

Where is the ignition switch on a oven?

THere usually isn't an ignition on an oven. You should have a pilot that's lit. If not you need to get an appliance repair man or a plubmer to fix your gas.

How much should it cost to repair an ignition coil assembly in a 04 VW beetle?

OMG!! This is SUCH an easy thing to do - do it yourself. The part costs between $20 and $30 and depending on which one you need to replace can take as little as 10 minutes. I paid over $300 to replace ONE last year and then found out during a spark plug change how easy it was (they sit right on top of the plugs) and I could just KICK myself....

How can you change your ignition switch on a caprice?

EJ48315: 1. Remove the four screws out of the back of the steering wheel and pull off the front cover / airbag assembly. 2. After removing the nut / washer / sleeve use a steering wheel puller to remove the hub. 3. Remove the turn signal assembly, should be 2 screws this will expose the ignition. 4. Remove the screw that goes through the backside of the ignition and the ignition should come right out.

Who should you contact to replace a screen assembly on a big screen TV?

A local TV repair service facility should be able to take care of this for you.

How much does a cigarette lighter assembly cost to repair in a 93 Nissan Altima -I get no power and some of the components popped out?

Google for entire assembly from scrapped vehicle. Should not be too expensive.

Which two parts in dot matrix and laser printer should be allowed to cool before repair?

#fuser assembly #print head

Will a super beetle engine fit in a type 1 68 beetle?

It should.. I have a 79 1600cc in my 65 beetle.

Why should you buy a new volkswagen beetle?

You should buy a new VW Beetle (Mexican 1977-1998) but you should not buy a VW New Beetle. They are the most difficult cars to work on, but they are very cute!!

How do you repair cvjoint assembly in1990 topaz?

you can repair cv joints if you have the right tools and knowledge, if not it would be better and less aggrivating if you had the job preformed by a licensed mechanic, this way you should have a guarantee and no guess work.

Do you have to replace the whole headlamp assembly when a headlight burns out in a 1998 vw beetle?

no, but you have to remove the complete assembly. There is a clip on the assembly inside the engine compartment - undo the clip and there is a tab that you push up and you should be able to feel the assembly move - sometimes you have to pry the outside of the headlight with a screwdriver and the whole thing slides out. Unplug the harness and open the back plastice and the bulb is there.

How do you take the lock cylinder out of the ignition switch in a 1987 gm bus?

If you take the assembly out, there'll be a slot in that assembly where you can insert a pick or other small tool, and that should release the tumbler. It'll come right out once you've done that.

Lost ignition key to 84 Caprice How do you start it?

You should change the key cylinder, it is available from most auto parts stores. The new cylinder will come with a new set of keys and they you'll be fine. Changing the cylinder isn't too hard, I managed it in about an hour when I was 15, you should likely also get a repair manual for the car as it will aid you with diagrams and steps for dis-assembly.

If the ignition switch locked up on a 2000 Chevy Impala how do you get it to unlock or reset?

I'm told this is a common problem that Chevrolet is aware of. Contact your local dealer. They should be able to replace the ignition switch and charge it back to Chevrolet as a warranty repair.

How do I replace the ignition tumbler on a 1994 Mazda B3000 truck. Key is broken off inside. I have the entire assembly off see no release hole pin etc.?

Remove the plastic cover to access the assembly that holds the ignition tumbler. Then find a hole offset but underneath the tumbler on the same assembly. Stick a firm thin pin of some sort into the hole and press the release pin. It should slide out easily.

What should be included in a repair estimate?

what should be included in a repair estimate

What is type of deadly beetle?

I think you should be more concerned with a beetle who can teach you to speak English properly.

Where can you find a diagram of rear brake assembly 1971 Chevy Chevelle?

get a chiltons repair manual from the library or autozone sells a small version in paperback that should show you.

Why is engine turning off on 1999 Honda accord?

Most likely the Ignition Switch. Honda issued a recall on this so if you haven't gotten the recall repair it should be free

What is the kerb weight of a 1972 vw beetle?

On my 73 super beetle it is about 2100.Yours should be pretty close to that.

Will 1975 beetle doors fit a 1971 super beetle?

They should interchange, the doors are identical and the hinges are the same.

How do you jerry-rig an ignition for a 91' craftsman ride on lawn mower?

go buy a universal ignition key for it or replace the ignition switch, or lastly, replace the switch with a simple toggle switch. there should be some type of repair shop in your town, right? or do it the old fashioned way, hotwire the darn thing :)

Does a 1975 dodge dart 318 have points ignition?

It should have electronic ignition.