It can run between $30 and $60 to replace the oil pan housing for this car. It all depends on where the part is bought, and who does the replacing.
It should be on top in the intake manifold it should be near the thermostat housing. Good Luck !
Not if it is working alright. however if you suspect its the worst for wear it would be a good idea,
if only the turn signals are not working,you should replace the flasher can
yes
yes it is very easy
The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.
(1) Open the hood; (2)unscrew the retainer from the back of the headlight; (3)pull the bulb socket out of the headlight assembly; (4)pull out the housing clips and remove the housing from the grill. NOTE:on later models there only 2 clips that are pulled up to release the headlight housing - one on each side. After pulling them up, simply move the headlamp housing forward from the vehicle. It may also be necessary to remove the headlight housing to change the bulb. - Haynes Repair Manual #36071; 1993-2005 Ford Ranger Pickups.
you undo the tire housing and pull off the exaust manifold. replace the muffler fluid and then your done
On a 1994 Ford Ranger ( which is OBD I , EEC IV ) should have an EEC TEST connection in the engine compartment ( P.S. I'm not a mechanic / technician )
detach the bulbs and remove the clips behind the headlight assembly
It should be located in the oil pan. On my ranger its on the drivers side.
There's two tabs by the housing you pull up on to release them