# How much should you torque the head bolts specs on a 1994 cutlas supreme?

33ft.lbs then 90 degrees

### What is the torque specs on the head bolts on a 2002 Honda 100 R dirt bike motorcycle?

You should measure the diameter of the bolts concerned. The information I have applies to the 250 cc as well as the 100 cc versions of this bike. For the 10 mm cylinder head bolts they torque to 27 to 31 foot-pounds. The 6 mm head bolts torque from 7 to10 foot-pounds. The 8mm cylinder cover bolt should torque from 15 to 20 foot-pounds. Hope this helps. .

### What is the torquing specs for the bolts on a 1999 blazer 43 intake manifold The book gives 132 pounds but this seems too much?

I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)

### Subaru 2.2 Head torque specifications?

{| |- | NOTE Step 1: Tighten all bolts to 22 ft. lbs. Step 2: Tighten all bolts to 51 ft. lbs. Step 3: Loosen all bolts, in reverse torque sequence, by 180° Step 4: Loosen all bolts, in reverse torque sequence again by 180° Step 5: Tighten bolts #1 and #2, in the torque sequence, to25 ft. lbs. Step 6: Tighten bolts #3,4,5 and #6, in the torque sequence, 11 ft. lbs. Step 7…

### What is the torque for cylinder head bolts on a Skoda favorite 1995?

According the the Haynes Manual (No. 1801, Skoda Favorit 1989-1996) the bolts should be tightened to between 17 and 20 Nm. Once all are tightened to this torque they should then be tightened a quarter turn each, and then another quarter turn each. The manual also quotes a torque of 20-23Nm for the cylinder head nuts.

### What is the torque rating for the head bolt on 93 subaru 1.8 4 cylinder engine?

NOTEStep 1: Tighten all bolts to 22 ft. lbs. Step 2: Tighten all bolts to 51 ft. lbs. Step 3: Loosen all bolts, in reverse torque sequence, by 180° Step 4: Loosen all bolts, in reverse torque sequence again by 180° Step 5: Tighten bolts #1 and #2, in the torque sequence, to25 ft. lbs. Step 6: Tighten bolts #3,4,5 and #6, in the torque sequence, 11 ft. lbs. Step 7: Tighten all bolts, in…