0
Auto Zone has a bumper epoxy/screen repair for holes & gouges for $7, I think it was made by Bondo.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the stock speaker size in a 1991 Honda accord?
6.5 fron and rear
How do you change brakes on a Honda Pilot 2006?
How do you change fron t and rear brakes on a 2006 Honda pilot lx
What year did Honda change from r12 fron to r134 freon?
1994-1996 Depending on manufacturer.
Where is horn in Renault megane 2001 dci?
The horn is located behind front panel ,very difficylt to reach without removing fron bumper
What size are the factory speakers in a 1998 Honda civic hatchback?
the rear are 6x9...if im not mistaken the fron are 4
Where is the battery on a Honda ses?
It's behind the maintenance cover under the fron of the seat. I found I had to remove seat/storage compartment to access it. Tam.
How do you replace the front bumper on a 1999 cavalier?
* Raise and support the fron of car securely on jackstands * Disconnect the bumper fascia from the left and right wheel well splash shield * Detach the bumper fascia from the fenders by removeing the two bolts * Disconect the bumper fascia from the front impact bar * Before removing the bumper fascia unplug the electrical connectors for the turn signals and parking lights * Remove the bumper fascia * To remove the front bumper energy absorber drill out all nine pop rivets * To remove the front bumper impact bar simply remove the four impact bar retaining nuts * Installation is reverse of removal.If you removed the absorber you will need new pop rivets
You replace the iat sensor fron a Honda civic vt and reset the check eng light but do not clear the code still in?
problem is not sensor but is in wiring to sensor or computer
How do you change the stator in a 1983 Honda goldwing?
Have to remove the engine for this job. Takes anywhere fron 10 to 15 hours for the job. The part cost is from $ 150.00 to $ 250.00.
What is Sør-Fron's population?
Sør-Fron's population is 3,292.
What is Nord-Fron's population?
The population of Nord-Fron is 5,926.
How do you replace wheel bearing on 1989 Honda accord DX?
Remove the wheel and all the brake hardware then remove the the spindle by taking the lower control arm loose and the up arm fron the body . Remove the strut and then with a hammer tap the cv axle from the center of the hub and take it to a machine shop to have it pressed in and out Is good info in how to do this in you tube. look the videos from (Erick the car guy) he got some good videos in how to do diferent repair on Honda cars.
