the BA-10/5 transmission (made by Peugeot) found in early 87-mid 89 Comanche and Cherokee with L6, 4.0 L engine specifies 4.9 PINTS (2.45 qt) of 80wt. GL-4 specification
I need to know fluid type speccifications for manual transmission Chevy 1985 s-10 5spd Chevy 1985 s-10 what type of manual transmission fluid
No.
Believe it or not, the factory manual calls for Automatic transmission fluid GM Dextron II for the 4 and 5 speed manual transmissions. Cheers Malcolm
Ford manual transmissions do not have dipsticks like most Ford automatics do The manual transmission fluid level is checked at the fill plug on the transmission
Just checked the manual...Dexron II
Should be a plug on the side of transmission Low fluid might have caused the sychonizers (?) to overheat
For a 1988 Ford Ranger : M5OD-R1 , 5 speed manual transmission ( transmission code " M " ) 2.9 liter V6 engine , rear wheel drive ( 2.8 U.S. quarts of MERCON automatic transmission fluid is used )
Manual transmissions use a variety of oils: regular motor oil, heavyweight hypoid gear oil or even automatic transmission fluid in some cases. Your owner's manual will tell you what your transmission calls for. If you don't have an owner's manual, either get one or call your local Ford dealer for the proper lubricant. Using the wrong lubricant can cause serious damage to the transmission.
In a 1988 Ford Ranger : If you have the Mazda 5 speed manual transmission ( transmission code " M " ) it takes ( 2.8 U.S. quarts of MERCON automatic transmission fluid ) --------------------------------------------------------------------------------------------- If you have a Mitsubishi 5 speed manual transmission ( transmission code " D " ) it takes ( 2.4 U.S. quarts of 80 - 90 W gear lube )
It is important to use the correct amount of fluid in a car. The 1988 Acura Legend takes about 3.2 quarts of transmission fluid.
Either loose bands or low fluid or bad fluid. Also could be a clutch problem.
how do i check the transmission fluid on a 1988 Honda accord, it is a automated