That is usually considered a partial valve job and most garages want just do head gaskets without shaving the heads at least and that means removing the heads from the motor(partial valve job). The last valve jog I had done on Ford engine 351 Windsor was about ten year ago and it was $600.00 then, the price know I couldn't tell you. I hope this give you some idealof the cost.
There isn't one. The 1995 Grand Marquis uses a lighting control prossessor. They are very expensive to replace. The part cost me $325.00.
$20.00 at advance auto parts
roughly around 275- 325 bucks range.
At least $75
This is not cost effective. It's quicker and cheaper to replace the compressor.
Its the bushings on your suspension, It will cost $200 dollars to replace at a shop.
Just had my 2004 grand marquis convertor replaced (making an aweful noise). it cost me $250 for the part and then labor etc. total of bill for installing etc was $472.61.
Average Cost per regulator is around $75 to $100 depending on the shop.
It depends on you mechanic, how much they charge per hour. It might cost you between 350 and 400 on average.
Depends on which shop you take it to. Usually around $350 for plugs and wires, etc.
I have just recently got my transmission repaired along with the gear ratios recalibrated for $900
to have the fuel pump (located in the gas tank), the strainer, and fuel filter replaced it cost me $140 in parts and $100 labor.
sorry that's a aod transmission they don't have modulators.the shift is controled by the kickdown cable
A rebuilt starter could cost from $ 100.00 to $ 150.00. The labor is 1 hour with the car on a hoist.
Likely the fuel filter is clogged so you need to change it. If you can keep the engine running by pumping throttle a few times at start up, and then it runs, check the filter; cost about $10.00. On My 1999 Mercury Grand Marquis I had to replace the Idle air control valve because it did stay running until it was warm
It came from the factory with R12. Due to the high cost of R12, I would have it converted to R134.
The 1996 Mercury Gran Marquis does not have a 318 V8. It has a 281 V8 (4.6 Liter). 318 is a Chrysler engine. O2 sensors are located screwed into the exhaust system. Start at the exhaust manifold and go backward and you will find them. The cost varies from site to site. Ask you local Auto Parts store for a price quote.
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
If you are talking about the coolant cross-over, on the intake, then the new modified one has to be installed. cost around $ 250.00 for the part, and 6 to 8 hours labor.
it would cost about 90 dollars just for the gaskets
If you want the best plug that will last around 150,000 kms , or 100,000 miles, cost is around 15.00$ each.
2002 Grand Cherokee with the 4.7 V8 engine head gaskets replacement would run aprox $1500 to $1800 parts and labor depending on your location.
The cost to replace valve cover gaskets on a 2001 Subaru Legacy is about $600. If the work is done at home the cost is only $100 to $200.
I just had to replace one in my daughters car, rebuilt they wanted $140.00 at the junk yard it was $80.00 i was lucky and got on out of a bone yard a friend of a friend works at for free, just hope it lasts longer than a few weeks lol.