Usually a voltmeter is connected across the load whether or not it is AC (Alternating current) or DC (Direct Current). A voltmeter is never connected in series with the load as this may cause serious injury or damage. The meter will absorb the full potential .
A voltmeter is connected in Parallel to the component whose voltage is being measured.
In parallel with the element you wish to measure the voltage across.
Ammeters are connected in series with the load under test. This requires the load be disconnected from the source, and the ammeter placed in circuit. Voltmeters are connected in parallel with the load under test. This does not require any circuit changes. Sorry, but WikiAnswers does not support illustrations.
One does NOT insert a voltmeter in a series cirtcuit...an ammeter can be inserted in series, though. A voltmeter is connected in parallel with the source voltage and low(ground) side.
If you are asking how a voltmeter should be connected in a circuit, then the answer is that it should be connected in parallel with the device across which you want to determine the voltage. This applies whether the circuit is d.c. or a.c.
Depends. What did you want to measure? If it's voltage drop across the incandescent element, then you had better hook up your infinite resistance voltmeter in parallel with the lamp.
A voltmeter can be connected in parallel with a resistor to show the voltage across the resistor.
Ammeter is coneccted in series with circuit but Voltmeter is connected in parallel.
In parallell.
A voltmeter is a device to measure the voltage in a electric circuit, and must have be connected in parallel to it.
A voltmeter should be connected in a parallel connection
in parallel
A voltmeter is used to measure potential difference across two points in an electrical circuit . The voltmeter is connected in parallel across the circuit element (resistance ) so that its inclusion in the circuit has negligible effect on total resistance and current flowing in yhe circuit A voltmeter has high resistance,if connected in series it will increase of circuit and reduce the current in the circuit
A voltmeter needs to be connected in parallel with the part of the circuit you are checking. It records a change in voltage, and has a high internal resistance, so it cannot be connected in series unless you want to screw up the circuit. Set the meter to AC or DC volts and place the wires of the terminal across the resistor, switch, or any other potentially resistive part of the circuit.
Ammeters are connected in series with the load under test. This requires the load be disconnected from the source, and the ammeter placed in circuit. Voltmeters are connected in parallel with the load under test. This does not require any circuit changes. Sorry, but WikiAnswers does not support illustrations.
Connect ammeter in series and voltmeter in parallel to the circuit
The voltmeter is connected in parallel between the two points whose potential difference is required.
One does NOT insert a voltmeter in a series cirtcuit...an ammeter can be inserted in series, though. A voltmeter is connected in parallel with the source voltage and low(ground) side.
The source voltage.