It all depends on whether you have had swimming lessons, but I would guess very soon.
Stabilizer can effect the pH some but usually it is a very minor amount. You should be able to swim the same day.
You should wait a couple of hours before swimming in a pool after adding PH minus. Check your water before swimming to ensure that the PH has been lowered.
You should wait a minimum of about 20 min.
It is advised to wait approximately two hours before swimming after adding pH to a pool. This gives the chemicals plenty of time to work.
You can swim a couple of hours after adding soda ash to your pool water. Be sure to test the water before getting back in to ensure that the levels are correct.
about 6 hour after shock or sooner if you use a shock and swim
NO! it is highly recommended you don't it could kill you or get you very sick
Adding an acid to a solution will lower it's Ph, but adding a base will raise it's Ph.
Adding water will affect the pH. Adding water will shift the pH towards the neutral mark. In the case of an alkaline solution, there will be a decrease in pH.
After adding conditioner, someone is advised to avoid swimming immediately or else it will rinse off. Give conditioner about an hour before swimming again.
You do not need to wait to swim after adding algaecide.
One of the relatively least harmful pool chemicals out there. 10 mins. with good flow.
It will mix very quickly so you can swim immediately. However what are you putting sulphuric acid in your pool for you should be using hydrochloric or mercuric acid
acid and alkalis can affect pH. Adding an acidic substance to a solution will lower its pH and adding an alkaline substance to a solution will raise the pH of the solution
no if it over 10 don't swim in it only you can swin in water with a pH of 8.0
Adding water will dilute the [OH-] and then reduce the pH toward neutrality.
Adding an acid the pH decrease.
Run your pump for at least an hour before going back in to make sure it is thoroughly mixed.
When adding a strong acid to an acidic solution pH decreases. Adding a strong base to an acidic solution the pH increases.