You can find a nice D.I.Y. with pictures here: http://laudeman.com/Volkswagen/golf_headlight.html
with your hand
I have a 1999 Forester, but I imagine the 2003 is similar in this regard. You don't actually need to remove the headlamp to replace the bulb. On my car, I unplug the wire from the bulb at the back of the headlamp, remove the large rubber piece around the back of the bulb, unclip the clips that hold the bulb in place, remove and replace. Cheers! Mark This is a good answer and is so just as stated. Thanks Mark! RicT
Yes you can my friend had them on his golf mark 4
The specific procedure may vary by model year... VW Volkswagen Golf sidemarker light bulb lamp replacement procedure: Purchase the correct replacement side marker light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the side marker light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations.
The most likely reason a low beam would be dim is that someone touched the bulb when installing it OR there is a leak in the headlamp body that allows moisture to collect inside the housing the bulb has gotten wet.
The mark 2 golf crank sensor is usually on the flywheel.
You don't actually need to remove the headlamp to replace the bulb. On my car, I unplug the wire from the bulb at the back of the headlamp, remove the large rubber piece around the back of the bulb, unclip the clips that hold the bulb in place, remove and replace. Cheers! Mark I just changed one of my 2000 Forester headlamp bulbs Saturday. Here's what I learned: The electrical connector on the back of the housing pulls off. Unfortunately after 8 years of use it doesn't want to come off. I used a screwdriver to gently pry it off, but still managed to dislodge the terminals from the old bulb. This is not a problem since you're replacing the bulb, just be aware that you may need some persistence. This is a 9003 bulb and I did as recommended by the fellow at the auto parts store and put a little dielectric grease on the terminals before installation. Good luck! Ken
Twist the socket 1/4 turn and pull out.
Open the trunk, remove the carpet lining and unscrew the black plugs and remove the burt out bulb.
mark 3
its not how you mark your ball, its how you mark your titleist.
"According to the famous author Mark Twain, golf is a good walk spoiled."