I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
the ign switch or the key & tumbler ???
it is located on the steering column
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
i have a 2003 Pontiac grand am, no start, does not even turn over. could it be the ignition switch?
change ignition switch and/or tumbler
how much to insall a ignition to a pontiac grand am se 1999?
It's really easy the switch is in the steering colume.
change the Ignition Lock lock switch
Replacing a steering column ignition switch on a 2002 Pontiac Grand Prix is not considered a major repair. The task is considered easy but if done wrong could be dangerous. It is best to refer to vehicle manual for the car to ensure proper direction is given.
The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.
Pontiac Grand ams dont have an inertia switch, actually no GM cars that i know of have them.
How to change oil pressure sensor on 3.4 sfi
If it looks the same it will probably work.
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
where are the oxygen sensors on a 2000 Pontiac grand am and how do you change them?
I got a friend whose key can't turn the ignition on her 2000 Pontiac Grand Am. She can't get the steering wheel to unlock either.
I think its the ignition switch.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
the steering wheel..
I had the same problem with my Grand Am and there is a recall on the ignition switch. I had to take the vehicle to an authorized GM dealer and they replaced it for me at no cost.
Driver side fuse box there is a switch you push to reset.