Mazda 6
Ford Escape XLS
Ford Ranger XLT
1995-2005 Chevy Cavaliers
How To

How to change auto trans fluid on 2004 Mazda 6?

535455

Top Answer
User Avatar
Wiki User
2007-01-07 03:31:21
2007-01-07 03:31:21

mercon V,im sure the other will work. Best bring to a dealer. But if you can access a tranny flush machine. Drop the skid plate, and the lines are right there. Also i belive you should use Mercon VI

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You do not change the trans fluid. It is a life time synthetic fluid.

User Avatar

There will be a fill plug on the side of the trans, fill it until fluid comes out of the hole and seal it back up.

User Avatar

drop trans pan with drain pan under the trans

User Avatar

You can"t check the trans fluid,we just took ours to the shop.The changed the fluid and done an inspection,cost around $100.00

User Avatar

To change the transmission fluid you have to drop the transmission pan. Make sure to change the filter at the same time. It is located under the pan and will come with a new pan gasket.

User Avatar

If it is the torque shift trans it uses mercron SP fluid be shure of what trans you have

User Avatar

as far as I know you can not add fluid because the trans. is a self enclosed trans.(if you have slippage, its time for repair.

User Avatar

A 2004 Ram 1500 uses ATF+4 transmission fluid only.

User Avatar

The power steering system uses ATF (auto trans fluid)

User Avatar

A 2004 Chevy Tracker uses standard Dextron ATF transmission fluid. This transmission fluid is used extensively among Chevy automatic transmissions.

User Avatar

Yamalube 4 or a comparable 10w-30 motor oil. Just doing a trans fluid change use 22.08 oz which is .69 quarts or 650 milliliters.

User Avatar

It is not recommended by Dodge, but it might work in an emergency.

User Avatar

Mopar ATF+4 (what is specified by Dodge) is synthetic.

User Avatar

Please change the Transmission Fluid to Mobil One Synthetic Automatic Transmission Fluid to prevent wear on clutch pack and wear on valve body. Also Mobil Synthetic Trans Fluid is higly resistant to high temperatures that will cause conventional auto trans fluid to produce varnish and increase wear. I currently have a 1997 Town Car with 148 thousand miles and the original trans is still in the car. Also the car shifts solid and is currently getting me 22-24 MPG at 60-65 MPH on Highway. Please be aware that the new synthetic fluid will last at least 60K miles before need for change. I have noticed that when my trans fluid needs to be replaced it has a sluggish shift between 1st and 2nd gears. After trans fluid change to new synthetic fluid the car immediately shifts well and gets increased mileage. Hope this helps. Jim

User Avatar

Remove the socket head bolt (drain plug) on the xmsn pan (faces right front tire) to drain the trans fluid. This bolt is removed with a socket wrench only (no socket). Clean the bolt while fluid is draining (has a magnetic end which attracts metal particulates). Replace drain plug. Refill thru dipstick tube. This will replace about 80% of the trans fluid.

User Avatar

You have to remove the transmission pan to drain the fluid. Change the filter(s). Reinstall the pan and fill the fluid.

User Avatar

Go to MPVclub.com they have step by steps

User Avatar

from inside the hood, not hard but it is complicated.

User Avatar

You can't change all the fluid without special equipment. Take it to a transmission shop.

User Avatar

How can i change transmission fluid on 2003 f 35


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.