answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2010-05-31 23:24:13
2010-05-31 23:24:13

Insert the ignition key into the ignition and turn it to on, the alarm should shut off.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions



To manually disarm a car alarm on a Honda CR-V, disconnect the battery for several minutes. You can also close the door and insert the key.



how do you disarm a car alarm on a volvo s80 2000


How to disalarm the alarm on a 1992 Toyota Camry


Contact the dealership for information.


Yes, if you ship a car to Hawaii, you will need to disarm the alarm.



To disarm the factor alarm on a Cadillac Sedan Deville, place the key in the ignition and turn it slightly without starting the car. Leave it in that position for 10 minutes and turn the car on.


No unless your car already came with an alarm and you are upgrading or changing models.


That the battery in your car is low and needs to be charged


depending on what you mean by disarm the car alarm, it may be as simple as putting the key in either the front driver or front passenger door and turning towards the rear of the car once or twice. the driver door keyhole on my 93 no longer works to disarm, so i use the front passenger door.


chang the wiring harness inside car.


Unlock the door with the key or use the remote.


To disarm a 1997 Toyota 4Runner factory alarm, place the key in the ignition. Turn the key about halfway ensuring the car does not start. Leave the key in that position for 10 to 15 minutes and start the car.


My battery went dead. I am trying to jump start the 97 landcrusier and the alarm is going off. I did not set the alarm The car sat in the garage for two weeks and battery is dead. Alarm is set and I need to get it of to start the car via cables. help George We have a 96 Land Cruiser. The battery went dead and we dealt with the same problem when trying to recharge the battery. We discovered a toggle switch on the drivers side under the dash below the hood latch and gas levers. Flip that switch and you should be good to go. Apparently it resets the alarm.



To disarm the alarm you need to put the key into the door lock and unlock the car. Putting the key into the ignition will not stop the alarm.


The alarm sounds because when it was installed they did not hook up factory alarm disarm. This is crucial because when the car is remote started, the car thinks someone broke in through the window and it trying to start the car while the car is still armed. If the disarm wire is pulsed the car then sees that whoever is trying to start the car wanted it disarmed and allows it so the car doesn't think it's being robbed. On most directed electronic alarms it's a Light Green/Black wire comming from the brain for Factory Alarm Disarm


TURN THE KEY IN THE DRIVERS DOOR FROM LEFT TO RIGHT


If you set the alarm (i.e. lock the car) and then disconnect the battery, the alarm will go off. If you disconnect the battery when the alarm is not set (i.e. when the car is unlocked) the alarm will not go off. (So don't try to nick a locked one).


Disconnect negative cable first from old battery and connect it last when installing new battery.


In many cases you can either push the "Alarm" switch on your remote car door opener (If it has one) or use the door key to lock/unlock the drivers door. This will usually "reset" the alarm. TommyTrouble



sounds like the battery short-circuited.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.