Check Clutch master and slave cylinders
The bleeder is located at the clutch arm on the bell housing. There is a fluid line going from the master cylinder to the clutch bleeder. This metal line has flexible hoses at either end. Follow this line down to the front of the engine just about in the middle and you'll find the bleeder valve.
Brake bleeder? Clutch bleeder? Coolant bleeder?
== == == ==
right nest to header is the clutch slave cylinder it has a bleeder screw
Most hydraulic clutch systems do have a bleeder valve.
In cylinder
where is the bleeder valve for 2003 Saturn ion clutch
The bleeder valve is on the front of the clutch housing. There is a metal line that goes from the firewall master cylinder to the slave cylinder. The metal line goes across the transmission. Follow it and you will find a bleeder screw with a rubber cover on it. Take the cover off to bleed the system.
Look at the back of the engine where the slave is for the clutch. The bleeder is right there. Just follow the hyd. line on the right side.
Same as for the brakes. Locate the bleeder, slack it and re tighten. Have someone pull in the clutch and hold, you release the bleeder, then tighten it while the clutch is still held in. Once the bleeder is tight, release the clutch and repeat till all the air is out. Make sure to refill the fluid.
I'm having a hard time finding the bleeder screw for my clutch on a 96 Chevy Cavalier 2.2? Can you help?
on the bottom of the clutch arm going into the tranny it looks like a little nipple like a brake bleeder screw