0
One reason that the pull cord on a Weed Eater Blower may have become stuck is because the spring broke. You can try to take it apart to fix it, but it can be difficult. The best option is to bring it into a repair shop.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you get plug out of blower on jeep green wire?
Release the lock tab and pull it out. It may be melted and stuck in there.
How do i replace the starter pull chord on my weed eater?
if your not a DIY person then take it to a shop, or remove pull cord cover, and pull out old cord, turn the pully" that the cord was on to wind up the spring, thread new cord into hole in pully tie a knot in end let it rewind cord back in, Get a armor cord they will never break they are tested to 1 million pulls,break 1 get 10 free i just changed everything i have a put the armor cord in it. armorcord.com
How do I deal with a Stuck chainsaw ripcord?
A stuck chainsaw ripcord is likely jammed. Remove the spark plug to see if that allows you to pull the cord. If it still won't pull remove the cover in order to see if the flywheel is able to move.
The heater on your 99 olds intrigue is squealing and no hot or cold air will come out what will fix it?
Pull the blower motor out and check both the motor, the blower wheel and the housing for any trash that may be stuck in it................
How do you reload cord on gas weed eater every time I reload it and pull it it stay's out it doesn't roll back up. Any answers?
The rewind spring is broken, not difficult to replace.
Snapper riding mower pull cord spins freely won't start?
The dog house on your recoil is broken or stuck. It's the thing that pops out and engages the shaft when you pull on it, it goes back in when you release the rope.
If your lawn mower has a key start and a pull cord do you still need to charge the battery or can you get by with just using the pull cord?
You can start it by using the pull cord, just be sure the key is in the ON position.
How do you run a ryobi weed eater?
1. put the carb into start position 2. Pull cord 3.put into run position 4. pull throttle. BTW you might want to ad gas! and if you still dont know how to run this then WOW your special
How do you get the pull string on a weed eater unstuck?
take the recoil off and use a small flat screw driver near where the rope is coming in. Pull on the rope (lightly)while you loosen it with the screw driver. Stick the screw driver between the rope and kind of cross it over.....wiggle it around..until it loosens up. Make sure you start with the very end of the rope coming from the pull cord handle and work your way around. More than likely it will be stuck right at the beginning
How do you pull the cord?
it depends on what it is on.
How can you open your trunk from inside the trunk?
Some cars have an emergency pull tab on the inside of the truck to release it. Look for that first. If not have someone open it if you are stuck inside it. May be able to see the latch from the inside and pull the cord if it has one.
How can I turn my citroen xsara blower motor off its stuck on full and wont turn off?
pull the carpet from the footwell you will see the bottom of the blower pull the black wire off it will stop the fan dont try to put a switch in here as the current is to heavy you can use a relay with a neg trigger to activate fan from a remote switch
