answersLogoWhite

0


Best Answer

The connector into the intake manifold of a GM 305 and 350 has been known to be quite fragile. If the connector has broken you have little choice but to replace the manifold.

User Avatar

Wiki User

โˆ™ 2006-03-29 17:53:36
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How to fix the heater hose that is inserted into the intake manifold on a 1995 305 v8?
Write your answer...
Submit
Related questions

Where is the starter on a 1995 Cadillac Eldorado?

under the intake manifold


Is a 1992 Chevy 350 tbi intake manifold the same as a 1995 Chevy 350 manifold?

There is no difference,,,


Where is the manifold in a 1995 Cadillac ElDorado?

The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!


Is there a gasket on the intake manifold for 1995 aurora olds?

i am replacing the starter on olds 1995 aurora


Removal of three sparks located behind the upper intake manifold on a 1995 Chrysler cirrus?

you must remove upper intake manifold to access these plugs


Where is the Iat sensor in an 1995 eagle talon esi?

It's on the intake manifold.


Where is the starter on a 1995 eclipse rs?

On top of the trans underneath the intake manifold.


How do you remove intake manifold 1995 lexus es300?

Follow the Youtube instructions.


How can I access the coolant pipe for LeBaron GTC 1995 without taking off the intake manifold?

the intake is the only way.


How do you change the lower intake gasket on a 95 Olds Cutlass Supreme 3.4DOHC?

Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.


Where is the fan sensor located for a 1995 Beretta?

It is on the intake manifold near the thermostat housing.


Why are THE rpms high on my 1995 Mitsubishi Galant?

large vacume leak in the intake manifold


What are the torque specs on the intake manifold on a 1995 Olds Aurora?

From 1995 Aurora Service Manual page 6A8-20/Lower Intake Manifold. Tighten the intake manifold bolts twice to 10 N*m (88 lb. in.) following the sequence in Figure 29. -----3-----1-------5 -7-------------------9 8------------------10 ---4--------2-----6


Where is your starter on 1995 cadillac concord 32 valve north star?

under intake manifold


How do you replace the starter on a 1995 Cadillac Sedan De Ville?

You have to remove the intake manifold to get to the starter.


Where is the oil filter on a 1995 Honda civic?

back of engine block under intake manifold


How do you remove alternator from a 1995 Dodge Caravan 3.3?

You have to remove the intake manifold to take it out the top.


What should you check after the fuses if there is no air coming out of the heater or air conditioning of a 1995 Dodge?

Make sure there is vacuum going into the passanger compartment. There should be a vacuum line from the intake manifold goung into the cab. GoodluckJoe


Is the intake manifold from a 1985 305 swappable to a 1995 350?

no, the bolt pattern on the small block Chevy intake manifold changed in '87 to the vortec head design, but if it doesnt have the centerbolt valve covers, then it will.


Can you use an intake manifold on a 1996 aurora on a 1995 aurora?

you should be able to being that they are identical motors.


Where is the oil sending unit for a 1995 Chevy Corvette?

It is at the back of your intake manifold screwed into the engine block.


What is the valve on top of the plenum on a 1995 Chevy S10 blazer?

Its called an "Intake Manifold Tuning Valve". Its function is to join or separate the two sides of the intake manifold. It has a minor effect on engine performance. It can be difficult or impossible to remove.


Where is the fuel rail for a 1993 ford aerostar 4.0l located?

I assume it would be the same as my 4.0 L in my 1995 Ford Explorer The fuel rail is a " flat " section between the lower intake manifold and the upper intake manifold


Where is the temperature sensor on a 1995 Isuzu Rodeo?

on the themostat housing where the upper rad hose meets the intake manifold


Where is the EGR valve on a 1995 Chevy Impala SS?

back of the intake manifold ...back of the engine center top