Ford Explorer
How To

How to install end links for stabilizer ford explorer?

353637

Top Answer
User Avatar
Wiki User
2015-07-15 19:57:25
2015-07-15 19:57:25

Depending on the year, this should be covered by warranty, as there was a recall for these parts on some years. Check with a dealer to see if this applies.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

If its the front link 3 piece desing, just pry up on the swaybar, insert the center section and run the long bolt through it.

User Avatar

How do I install passenger side mirror 2010 Ford Explorer

User Avatar

How to Install Front Brake Pads Check Related links below.

User Avatar

I need an answer to my question. how do you remove the dashboard to install CD player in a 2002 ford explorer. thank you.

User Avatar

The bar is called the stabilizer bar and the small rod at each end are called stabilizer bar links. The stabilizer bar links attached the stabilizer bar to the lower control arms. This assembly reduces vehicle roll during cornering. This is good information for you, call Strutmasters they can help you with any of your suspension needs on this vehicle.

User Avatar

The first model year that a Ford Explorer was available with a third row seat was ( 2002 )

User Avatar

Here's a good link: http://www.installdr.com/

User Avatar

It is in the differential and secured by a 10mm bolt.

User Avatar

I believe it is a 15mm nut and bolt. You need to undo both stabilizer links and pull the bolt out of the stabilizer link shaft. Sometimes these parts will rust together or corrode and can be tough to pull apart but they will come apart. Then you just replace the old with the new. total job time for both sides... 20 - 40 mins. hope this helps.

User Avatar

Get some tool's and pull it out install new starter!

User Avatar

WikiAnswers cannot show diagrams or pictures.

User Avatar

Instualation of a heater core on a 1999 Ford Explorer V6, how do you install the heater core.

User Avatar

No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.

User Avatar

How do you install a rear sway bar on a 2003 f 150 4 wheel drive

User Avatar

belt tensioner fell off this morning.I need to know how to install new one.

User Avatar

See the Related Links for "How to Install Infant Car Seat" to the bottom for the answer.Hi, I also have a 1998 Ford Explorer and I was able to put my infant car seat in the middle of the backseat using the seat belt to secure it.I would give you more details, but the related link that they mention above this note, gives all the steps plus some. Another good site is http://www.squidoo.com/howtoinstallinfantcarseat Good luck! Just get it inspected after you install it, its usually free.

User Avatar

Ford Explorer was created in 1991.

User Avatar

On a 1995 Ford Explorer : No ( at least my 1995 Ford Explorer XLT doesn't )

User Avatar

FOrd Explorer 2008 comes equipped with Kill switch that you activate through menu in dash.

User Avatar

I am working on changing my 93 Explorer ignition switch now. As soon as I figure it out I will let you know. :-) Still working on it.

User Avatar

www.allexperts.com go there and just click the right link for you it helped me......

User Avatar

ford explorer remeto pass


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.