answersLogoWhite

0


Best Answer

you should research din removal tools or the coat hangar trick at http://www.i-hacked.com/content/view/213/45/

asides from that you will need a wiring harness for the aftermarket head unit

User Avatar

Wiki User

โˆ™ 2008-05-19 04:30:48
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How to install stereo in 1993 cougar?
Write your answer...
Submit
Related questions

Where can you find the wiring diagram for a 1991 Mercury Cougar stock radio?

if you are trying to install the factory stereo to it...it should be the same plug...if you are trying to install the stereo for a cougar on a different car you need to buy the plug for that stereo and then a harness for the other car...


How do you install a car stereo in a 1987 Mercury Cougar?

I find that by going to www.crutchfield.com they have a lot of advice. I just installed a car stereo in my 1993 courgar and you need a special factory radio removal tool that has 4 prongs that will remove the radio. Then, you need to install the new radio as per directions. Additional mounting brackets may be needed.


How do you take out a stereo in a 1992 Mercury Cougar xr7?

If it's anything like the Cougar LS, there should be 4 holes in the factory stereo. There is a U shaped removal tool that you can get (they come in pairs). They will have instruction on how to pull the stereo on them. If you don't want to be bothered to do this yourself, just have the place you got the new radio from install it for you. Should cost an extra $100 or so.


How do you install stoplight switch on a 1972 cougar?

How do you install a stop light switch on a 1972 cougar


What year did Mercury Cougar have CD stereo?

2002


Stereo wiring diagram for a 1993 ford aerostar?

Try the,Install Doctors at www.installdr.com. Good site for finding stereo wiring diagrams. Hope this helps. Good luck


What type of refrigerant does a 1993 Mercury Cougar use?

What type of freon does a 1993 cougar use


What are the color codes for stereo wiring harness for a 1987 Mercury Cougar?

buy a wire harrnes install kit they will have collored wires that will match the line up of your aftermarket car stereo. and then you don't have to cut any of the factury wires. if you go to sell the car you can put the facutery stereo back in


How do you change water pump on 1993 Mercury Cougar?

how do you change a water pump on 1993 Mercury Cougar


How do you install an after market stereo in a 1989 Acura Legend?

How do you install an after market stereo in a 1989 acura legend?


Brake fluid 1993 mercury cougar?

A 1993 Mercury Cougar takes ( DOT 3 brake fliud )


How do you install an aftermarket stereo in a ranger?

Check with Crutchfield.com. They can provide step by step diagrams of how to install your new stereo.


Stereo install BMW?

Attached the wiring harness and the antenna cable to the back of your stereo. Slide the stereo into the stereo slot. Tighten the stereo with the stereo retaining screws.


How do you install a stereo in a 1992 Honda Prelude?

The easiest answer to this question is "www.installdr.com", there is a complete .pdf including diagrams on how to install the stereo for a 1992 prelude.


How do you change rear wheel bearings in a 93 cougar?

Remove the wheel from your 1993 Mercury Cougar. Loosen and remove the wheel bearing nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.


How do I install a second battery in the trunk of My car for my stereo?

connect the positive and negative to the stereo


How do you install antenna for 1968 cougar?

you have to remove the fender


Can you install a flip out stereo in a 2002 impala?

Yes you can install a flip out stereo in a 2002 impala I got a pioneer avh-5200 installed in my 02impala


How do you replace lower ball joint on 93 Mercury Cougar?

Remove the tire and wheel from your 1993 Mercury Cougar. Remove the ball joint retaining nut. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.


Is it a good thing to have for the car?

Mounting kits for cars are used to install stereo systems. So if you don't have a stereo in your vehicle there is no need to keep one in the car. They are generally easy to use though to install a stereo.


How do you replace stereo in vy?

Begin by removing the decorative cover to your stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.


How do you install 1993 rodeo distributor?

install distributor rodeo 1993


Where is the module located on a 1993 Mercury Cougar?

In the trunk


How do you change remove the stereo on a Vauxhall tigra A?

Remove the retaining cover from your stereo. Remove the stereo retaining bolts. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.


How do you install a stereo in a 1995 Buick Lesabre OR A WIRING DIAGRAM?

Connect the wiring harness to the back of your 1995 Buick LeSabre stereo. Secure the stereo with the stereo retaining screws.