answersLogoWhite

0


Best Answer
Copy

did u ever figure it out?

User Avatar

Wiki User

โˆ™ 2006-03-19 20:58:14
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?
Write your answer...
Submit

Related Questions

How do you replace the crankshaft sensor in a 1985 Oldsmobile Calais Supreme LN7 3.0 liter engine?

changing the crankshaft sensor


What is the firing order for a 1998 Oldsmobile Achieva?

Which engine?


How do you replace the water pump on a 1995 Oldsmobile Achieva?

is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol


Where is the oil filter located on a 1997 Oldsmobile Achieva?

Which engine is in this car?


Where is the crankshaft sensor on a 1998 Oldsmobile Bravada?

On front cover of engine by crankshaft pulley.


Where is the starter on a 98 Oldsmobile achieva?

Under car by where engine and transmission meet.


Where is the EGR valve on 1994 Oldsmobile achieva 2.3l?

There is NOT an EGR valve on this engine.


Where is O2 sensor on 97 Oldsmobile Achieva 2.4 liter engine?

They are in the exhaust flow


Where is the thermastat in a 1995 Oldsmobile achieva?

Should be in a removable housing at the engine end of the upper radiator hose


Where is the thermostat in a 1995 Oldsmobile achieva?

Should be in a removable housing at the engine end of the upper radiator hose


How do you replace crankshaft position sensor Oldsmobile 1988 ninety-eight?

You have to dismantle the entire engine,,,NO YOU DO NOT ITS JUST YOU HAVE TO DRAIN THE OIL TAKE THE OIL PAN OFF AND GET THAT DANG SENSOR TAKEN OUT THEN REPLACE IT!!


Where is the thermostat located on a 95 Oldsmobile achieva?

Check in the removable housing at the engine end of the uper radiator hose


Where is th EGR valve on a 1995 Oldsmobile Achieva 2.3l engine?

The EGR valve, on your 1995 Oldsmobile 2.3 liter engine, is located on the side of the air filter housing. The valve should be labeled as such.


How do you Replace crankshaft on 1999 mercury villager?

You don't, you replace or rebuild the engine.


Your 96 achieva engine cranks but will not fire whats the problem?

There are several reasons why a 1996 Achieva engine cranks but will not fire. A few of the reasons could be a bad ignition control module, ignition coil pack, or a crankshaft position sensor.


Where would you find a thermostsat on a 1995 Oldsmobile achieva?

Should be in a removable housing at the engine end of the upper radiator hose


What happens if the crankshaft position sensor goes out in a 2001 Oldsmobile intrigue?

The engine won't start.


Location on a crankshaft on a 3.4 engine on a 2001 alero Oldsmobile?

A Crankshaft is an internal engine part connecting all your rods and pistons together to simultaneously turn all internal engine parts at a specified time.


You just put engine coolant on your 1995 Oldsmobile achieva and the engine coolant light wont turn off?

The coolant level switch on a 95 Achieva has a sticking problem. If you tap the coolant tank near the sensor the light will go out


Where is the horn in a 1992 Oldsmobile Achieva?

Hey Benjamin==It is on the left side of the engine compartment under the headlight . Good luck Joe


Where is the starter on a 1994 Oldsmobile cutlass ciera?

The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.


Can you replace a crankshaft in a 1991 Geo Tracker without pulling engine?

No


Do you have to get under the car to change the crankshaft on an 04 pt cruiser?

You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.


How to replace a power steering hose on a 2001 Oldsmobile aurora?

how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine


How do you replace a serpentine belt on an 97 Olds Achieva?

replacing achieva serpentine on a 96i have a 96 and you have to completely remove the motor mount and all of the bolts holding it on the engine to replace the belt,also carefully jack up the engine since it will fall on the ground if you take off the mount