I'm pretty sure that only 4WD trucks have torsion bars.
Instead of using coil springs on the front suspension torsion bars are used from the lower control arms to the frame ( my 1995 Ford Explorer 4x4 has torsion bars , my dads 73 Dodge Coronet had torsion bars ) If you look at a lower front suspension that has torsion bars you will see the torsion bars going from the lower control arms rearward
A Dodge Ram does not have torsion bars.
The tundra does not have torsion bars, buy a lift.
as the rear is torsion it is not straight forward. the torsion bars have to be removed one side at a time, with the torsion bar out simply adjust hub the required amount and replace torsion bar. then do the other side. this can be hard as the bars can be difficult to remove. best left to professional should cost between £60-£100
Depends on whether you have coil springs or torsion bars.
no the torsion bars didn't come out til the 1998 model year
I own a 1989 dodge Dakota and it has torsion bars that can be raised and lowered. Just follow the torsion bars from the front to the back and look at where they stop there should be a 7/8 bolt that you can turn clockwise to raise the truck and counter clockwise to lower it
yes 02-05 have torsion bars 06 and up have coil overs
I believe the 4x4 has torsion bars and the 2 wheel drive has coil springs
If it's a torsion bar suspension you can take the tension off of the bars by turning the bolts at the back end of the bars. NOT SUGGESTED.
Crawl under the truck. Look at the torsion bars (if you can't find the torsion bars, just take it to a shop and have them do it). The torsion bars will have a bolt at each end; take those bolts out. You might want to have the frame held up with jackstands when you do that, I'm not entirely sure how much the torsion bars are involved in keeping the truck from falling on your face (probably a lot).
Vehicle does not have torsion bars