The fuel filter should be located under the frame rail of the truck towards the rear. Just follow the fuel lines from the engine back. It will either have snap in connectors ,(which require a special tool to release) , or will have 3/4 and 5/8 flange fittings. Remember to release presure at the service valve on the fuel rail on the engine brfore beginning. Take the bracket lose from the frame and take the lines loose taking care to remember the proper flow direction and replace with the new one. it should start after it purges the air from the new filter.
If it is carburated itis in the inlet nut of the carb. If injected it is inline.
It is INSIDE the fuel tank. In 2004 chevy moved the fuel filter from inside of the drivers FRAME RAIL to the fuel tank.
its in the fuel tank, built in as part of the fuel pump.
The 1986 Chevrolet C10 pickup truck fuel filter is located inside of the fuel tank. The fuel tank will need to be removed in order to change the fuel filter.
In 2004 Chevy moved the fuel filter from the drivers side frame rail and believe it or not they put it inside of the fuel tank.
1985 CHEVY PICK-UP IS CARBURATED... THE FUEL FILTER IS LOCATED IN THE CARB.. BETWEEN THE FUEL FEED PIPE AND CARB. IT'S A PAPER TUBE STYE FILTER. GM# 7028281
A Fuel filter on 1994 Chevy Mark truck in under the truck near the oil plug. This should be easy to find.
1985 Chevy fuel filter should be where the fuel line screws into the carb. use a 1 inch wrench and unscrew the nut that holds the line to the carb pull out line should be a small filter ,spring and washer
Midship, drivers side.
In 2004 Chevy moved the fuel filter from the frame rail and put it inside of the fuel tank. That's were yours is at, In the tank.
The fuel filter is uder the driverside door outside of the truck. Underneath the truck you will see the frame ( C-beams) of the truck. Its on the inside of the driverside C-beam.
The fuel filter is probally underneath bolted to the frame, the fuel line comes out of the gas tank and is secured to the inner part of the frame and the fuel filter should be bolted to the frame about the center of the truck.