answersLogoWhite
Car Stereos and Speakers
Honda Civic
Honda Civic DX
Honda Civic EX
How To

How to remove a stock stereo from a 2001 Honda Civic?

484950

Top Answer
User Avatar
Wiki User
2011-09-13 05:43:34
2011-09-13 05:43:34

I did have a 2001 Honda civic, and the way to get out that radeois, first thing you ash tray, then they are two 10mm screw underneath the console one is in front and the next is to the left. When u done that just pull the whole set that the radeo and the AC etc Out. And you good to.

email me at lonerangers_1330@yahoo.com

1

Related Questions

User Avatar

To remove a stock stereo from a 2005 Honda Civic LX all the mounting bolts need to be off. The center console will have all the necessary screws removed to reach the mounting bolts. When all the bolts are removed the radio unit will slide out.

User Avatar

To remove a stock stereo, you will first need to remove the bezel from the stereo. Then, pull the stereo out of the dashboard and remove the wiring harness.

User Avatar

http://www.installdr.com/InstallDocs/Honda/PDF/466053.pdf

User Avatar

195/60R15 are the stock size tires on my 2004 Honda Civic.

User Avatar

Remove the retaining cover from your 2003 Suzuki stock stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness and the antenna cable from the back of the stereo.

User Avatar

i have a 92 Honda civic si... it goes like 102... fully stock..

User Avatar

No. not if it is stock.

User Avatar

The stock stereo, from a 2003 Nissan Altima, can be removed by first removing the stereo front cover. Next, remove the four screws. Pull the stereo out and remove the wiring.

User Avatar

1998 Honda civic DX should have a 107 HP stock

User Avatar

If you have changed the stereo the alarm settings will reset. The dealership reset those for Anti Theft protection.

User Avatar

you have to putt the dash apart starting with the shifter knob, have fun.

User Avatar

for the 96-99 models, unscrew the panels underneath the steering wheel, take out the glove box, and the panel attached to the cigarette outlet. they should all snap out after unscrewing them. Once you do this, look up underneath the dash at the back of the stock stereo. there with be two screws, you can either use a 10mm or Phillips head to take them out, it then easily slides out from there. good luck! Try www.streetdreams.com/tech/Honda/civic

User Avatar

everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the reference section for FREE to make copies of...read up and fix like a pro!! :) Dave

User Avatar

Remove the decorative cover to your 2001 Chevy Lumina stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Remove the antenna cable.

User Avatar

Well if you have a stock deck the first thing you need to do is make sure you buy a dash install kit with the after market deck you want to install. The stock stereo comes out easily after you remove the two screws on the side of the panels that hold the deck in place. The screws are by the drivers right foot and the other is by the passengers left foot.

User Avatar

screwdriver, and then pull hard enough to rip out the wires and then there you have it. the way to remove a stock stereo the theft version

User Avatar

Where can I find a passenger side door wiring diagram for a 1996 Honda civic ex coupe?

User Avatar

The stock front speaker size on a 2002 Honda Civic is 6.5 inches. These speakers are located inside the door panels of the vehicles.

User Avatar

You pull the dash from below the shift knob. (Put your finger on rubber sack, and dig down and yank the plastic) Remove the shift knob Pull bottom dash over shifter pull upper dash from the bottom and just yank the whole thing out.

User Avatar

A 2003 Honda Civic with an OEM alarm system can enable program mode. This mode will allow the user to reset the alarm. To enable it turn the car on then press the lock button on the remote. Do this sequence three times in five seconds.

User Avatar

You must remove the front of the dash. Everything around the stereo. Very time consuming. Just remember where the parts and all the screws go when you go to put it back together. It is not that difficult. Good Luck.

User Avatar

pull it out and disconnect the harness. put a new harness on so when you sell it you can out your stock radio back in.

User Avatar

* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.