It should be located over by the left kick panel under the dash
What about it?
Begin by removing the dashboard speaker covers on your 1989 Chevy S 10 Blazer. Remove the speaker retaining screws. Remove the speaker wiring harness. The speakers will come out.
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
The buzzer that lets you know the key is in the ignition in a 1989 Chevy Blazer is in the steering column. To access it you would need to remove the steering wheel with a special tool, or remove the ignition assembly. The key makes contact with a tab that activates the buzzer.
you dont, if you want to disconnect it then remove your front drive shaft.
No it will not even bolt up. GM redesigned the transmission and its not even close to being the same as the 1989 trans.
Are you asking about the trim panel above the glove box or the trim panel in front of the radio or the trim panel around the instrument cluster? Ask again telling us which panel you wish to remove.
yes, 82-93 are the same besides grill design
1982 - 1994 (early year models).
I believe that the first digital cluster on a S-10 Blazer was in 1989.
Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...
There is no adjustment to my knowledge.
The question you ask is too involved for a proper answer. You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
i have a 1989 chevy blazer gos in 4x4 drive but front wheels are not pulling wat do i do about that
No it does not.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
It will be a 305 or a 350 fuel enjection engine ( TBI )
The 89 model does not have a VSS.
look at the info sticker inside drivers door. My 89 blazer came with 31x10.5x15 from the factory.
One screw you won't see is under the lock switch. Anywhere you find a hole there will be a screw some are just deeper than others. After you remove the screws the panel will pop off.
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.
The 1989 Chevrolet Blazer 4.3 liter engine starter can be found on the right hand side of the engine. The starter will be near the back of the engine.