Take it off as you would a normal bolt. It is a 'Right Handed' thread. Use a breaker bar or impact wrench. I also used a breaker bar with a 15/16 inch socket. I place the breaker bar up against the frame and after removing the spark plug wires at the coil I tapped the ignition key. It took a while but eventually it came loose.
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
With a balancer puller tool. With a balancer puller tool.
On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.
The harmonic balancer tool is made especially to remove the balancer. Some stores will loan you the tool with a deposit.
use a harmonic puller
Go to Autozone and tell them u need a harmonic balancer puller
Remove upper core support, remove radiator, remove belts, using a hormonic balancer puller(specific for chrysler) remove balancer.
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
It is located by the harmonic balancer right next to it to remove it you must take the hb off to properly take it off...
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
You need a balancer puller to remove it , It don't just slide off.
take off the serpentine belt and crank pulley and you will need a harmonic balancer pulley to get it off.