answersLogoWhite

0


Best Answer
Copy

Remove the bezel around the door handle (pops out) disconnect power lock connector

Remove the power window switch (pry up towards front then slide towards front) disconnect connector

Remove reflector (pops out) remove 7mm nut

Stick fingers between door and panel and pop the push pins out, do not go go crazy here as you will break the door panel handle retainers.

Lift up on the panel, you will see a metal bracket that slides into two black plastic retainers if you are looking through the power window switch hole.

Disconnect speaker wires

Once panel is off, push in on the metal spring clips holding the black plastic boxes and slide off, re-attach to metal bracket on door panel(makes install easier) Install is reverse Hope this helps

I just popped my Mom's off yesterday. Basically just pry it off enough to get a finger hold and then pull HARD. There were no screws or anything to take out first, it just pops off. They were little green (I think) plastic ribbed pins that held it on, but were very stiff. You pop those loose around all sides and then pull up and out. When you get to the point you think you will break something, pull even harder and it will pop loose. This was for the rear doors, but I'm sure the fronts are similar.

User Avatar

Wiki User

โˆ™ 2007-11-03 18:42:49
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: How to remove the door panel located on a 2000 Buick LeSabre?
Write your answer...
Submit

Related Questions

Where is the fuse panel located in a 1997 Buick Lesabre?

Under the dash on the driver's side, it's covered by a removable plastic panel.


2001 buick lesabre fuse panel diagram?

The fuse panel diagram for a 2001 Buck LeSabre is located in the service manual. It outlines the location of each fuse and the components it attaches to.


Where is the fuse panel located on a 1999 Buick LeSabre?

Look under the dash board on the driver's side near the steering columnMay have to remove plastic panels for access


Where is the fuel pump fuse located on a 1987 Buick Lesabre?

Fuse panel. Open and read your owner's manual.


How to remove the door panel on 1999 Buick LeSabre?

Using a screw driver, remove the screws and the clips that are in the door panel. Gently pull the door panel away from the frame, remove any wire connectors and the door panel should be free.


How do you open an 87 Buick LeSabre with a slim Jim?

The lock assembly is located in the center of the door panel of 1987 Buick LeSabre. Use of a Slim Jim is only legal for locksmiths and law enforcement officers.


Where is the blower motor for a 2005 buick lesabre located?

The 2005 Lesabre has the blower motor mounted under the dash. It is under the glove box on the firewall behind a panel.


How do you remove a front door panel on a 1991 Buick LeSabre?

Using a screw driver, remove all of the screws in the panel, then remove all of the clips and gently pull the panel away from the frame. Remove any wire connectors and then pull the panel off the rest of the way.


Buick lesabre fuse panel diagram?

what year is the car fisrt of all? If it is a 1989 it is located on the driver side near the light dimmer switch. There are two thumbscrews you have to remove to access the fuse box, on the inside of the panel there is the diagram.


How do you replace a license plate light bulb on a 2004 Buick Lesabre?

You must remove the entire tailight panel - remove trunk liner and the recessed nuts.


How do you remove a cassette player from the dashboard of a 1990 buick lesabre?

there is a black trim panel over the a/c controls-this pops out and there are 4 screws behind the panel. remove these screws and voila--the stero is accessible.


Where is the fuse panel on a 2002 Buick Lesabre?

The fuse panel is under the rear seat with the battery.


Location of heater blower motor in 2002 buick lesabre?

It is located under the right side off the dash. Remove the plastic kick panel and you will see it. The screws to remove the panel are just under the glove box. Once the panel is removed you will see the motor housing it has an electric plug with three wires.


Where is the flasher located on a 1990 buick lesabre?

Left side of dash, remove panel for the fuse box then unclip fuse box and push it forward. Flasher is in a retaining clip attached to the steering column.


How do you remove the mirror bolts on a 1997 buick lesabre?

If you need to remove side view mirror: you need to remove door panel and there should be 3 nuts securing mirror to door.


What is the procedure for replacing a 2001 buick lesabre window?

remove door panel, take out old one, put in new one, replace dor panel. This ain't rocket science


Where is the fuel pump located on the 1985 Buick Riviera?

There is an access panel in the trunk you have to remove the carpet then you'll see the panel.


How do you change the ECM on a 1994 Buick Lesabre?

I do believe on your model the ECM is located under the right hand of the instrument panel. If you really need to remove the ECM I would likely suggest a Haynes repair manual for this operation.


Where is the fuel pump relay located on a 1997 Buick LeSabre?

It is in the fuse panel on the passenger side underneath the dash board next to the fire wall.


How do you remove door panel on Buick Lucerne?

how do you remove left rear door panel on a 2008 buick lucerne cxs.


Where is the pcm located in 94 buick lesabre?

The PCM (or ECM) is located on the interior of the car on the passenger side. To access the PCM/ECM remove the kick panel just beneath the glove box and it is right there. Disconnect the three electrical harnesses and and sucuritity clip and it's out.


How to change a brake light on a 91 buick lesabre?

Should have an access panel inside trunk


Where is a kick panel on a 1998 Buick LeSabre?

Area where your left foot rests while you are driving


How do you access the temperature contol panel on a 2005 Buick Lesabre?

By braking it down and fixing all parts


How do you adjust the shift indicator on a 1990 Buick LeSabre?

Should be a removable panel under steering column. where adjusting screw is located Place gear shift in neutral to adjust