Remove the bolt from the handle for opening the door, remove the bolt from window opener, remove the screw in the opening where the door handle is located. Then starting at the bottom and work your way up each side pull the panel away from the door for it is held in place by spring like clips, when the bottom and sides are clear just lift up on the panel for it only locks down over on the top. To install reverse this procedure. Hope this helps. Pat
Wiki User
∙ 2007-04-13 18:01:57Remove the 1992 Dodge Dakota inside door panel. The door handle mechanism will be visible. Remove the door handle linkage. Remove the door handle retaining bolts.
disconnect the battery, then drop the sterring column, remove the insterment panel and the bulbs will be on the back of the insterment panel
it is not a 350 dodge makes the 360 5.9
how to remove the door panel on a 1992 mercury cougar
there is no such car as a 1992 dodge avenger, so i guess you don't remove one.
on passenger side kick panel
I have a 1992 Toyota pickup, Had a HARD time finding the horn relay myself. The horn relay on my 1992 Pickup is located on the drivers side, to the right (or towards the front of the truck) of the small fuse block that has an access panel door on the kick panel, you have to remove the kick panel to see the relay, in my case it was just unplugged, plugged it back in and horn now works. The relay has printing on it and it says "HORN RELAY" Good luck! Laterz, Len P :) I would like to find the Fuel Pump relay on my 1992 Toyota pickup.
Drop the fuel tank or remove the bed.
== ==
Dodge does not use inertia/reset switches.
.You can remove the door panel, from your 1992 Mercedes Benz, by gently prying on the retaining clips. There are approximately 12 retaining clips
under the dash behind the passenger kick panel