Open trunk and remove the two (now) exposed hex head bolts with a 10 mm socket (the bolts are located at the innermost edge or flange of the tail light assembly). Then carefully pull the tail light assembly straight out to the outward side (not toward the back of the car; but to the side). The tail light assembly has two pins which plug into sockets in the side of the car body in the body recess. You can see the sockets from inside the truck if you pull the inner carpet trim away from the inside of the trunk. The light sockets are a twist into the back of the tail light housings. To reinstall: carefully plug the tail light housing back into the sockets from the side and then reinstall the bolts. I later discovered illustrations of this in the later pages of the owners manual. Tyrone Johnsen
It's removed from inside the rear compartment. Open the rear hatch and on the inside of the light you will find a snap-off cover. open it and remove the light assembly with a 1/4 turn. The bulb assembly should pop out
after removing the two nuts from the rear light how do tou get it out of the rear panel
Lower tailgate and remove two screws. Pull assembly to the rear and it will release.
You must remove the entire light assembly as follows: Lower the tail gate and remove the two small screws that screw into the side of the assembly. Next remove the two screws on the outside of the assembly that are accessible through long holes on the outside of the assembly. Pull the assembly back to expose the rear where the lights are located.
Remove the two securing lock pins and pull out
The complete assembly comes off by removing 4ea screws on the outside. Then remove the small plate on the rear of the assembly to get to the bulb.
The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
If you open tailgate there should be 2 black screws against rear fender - remove these and assembly should pull-out
There are 2 torx screws you need to remove located on the left/right side of the light. You can only see them with the trunk open. Then remove the light assembly. The sockets twist 1/4 a turn and then remove. Replace the light and reinstall assembly
to get in to the rear light panel open rear hatch on the in where the light are is a platic cover with two to three scrwes undo it light housing come out
the cover does not come off, you must remove the entire light assembly and remove the bulb from the back side