answersLogoWhite

0


Best Answer

Front pads are an easy. Remove the wheels, and locate the lower caliper bolt. It's facing inwards and is about four inches long. Remove the bolt and pry the brake pad holder(along with the pads)upwards to pivot the assembly around the upper caliper bolt. Now you need to push the brake piston inwards in order to make room for the new pads. You can either loosen the bleeder valve (it's a small bolt on the top of the caliper) or open the brake fluid resovoir cover in the engine compartment. Using a piece of wood push the piston all the way in. Take care not to damage the rubber seal and do not use excessive force. Remove the pads. Retain the metal wire clamps and flat steel spacers. Apply generous amounts of brake pad paste on the back side of the pads and reinstall them along with the clamps and spacers. Install the pads, caliper bolt and be sure to bleed the brake lines to get rid of all the air bubbles in the brake lines. Install the wheels and test drive. If the brakes feel ineffective, bleed the brake lines. Total time no more than an hour.

User Avatar

Wiki User

โˆ™ 2015-07-16 18:30:08
This answer is:
User Avatar
Study guides

Can slotted or drilled rotors be machined in a brake lathe

โžก๏ธ
See all cards
1.0
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
1 Review

Add your answer:

Earn +20 pts
Q: How to replace 1993 Corolla front and rear brake pads?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the front brake pads on a 1993 Ford Aerostar 4.0?

Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.


How do you replace outside driver's door handle on 1993 corolla?

How do you replace the panels on the outside of a 1995 pontiac Grand am?


What makes brakes lights stay on 93 Toyota Corolla?

A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.


Is 1993 Toyota Corolla a rear wheel drive?

No. Toyota changed the Corolla from rear to front wheel drive in 1983 for the 1984 Model year, with the exception of the SR5 Corolla, all other Trims and sub~models were Front WD


What is causing your brake lights not to work on a 1993 corolla the bulbs are fine?

bad fuse,bad switch or bulb montiner


How do you replace a light bulb for a Toyota Corolla 1993?

omfg what light bulb? the one on the back porch?


How long does it take to replace a water pump on a 1993 Toyota corolla with a 1.8L engine?

2 hours


What is the wiper blade size of a Toyota Corolla 1993-2001?

The 1993-2001 Toyota Corolla takes 20" driver side and 18" passenger side replacement windshield wiper blades on the front.


1993 corolla have speedometer cable?

si http://www.corolland.com/corolla/1993-1997/1993.html


How do you change the front pads on a 1993 Areostar?

You need to remove the front tires to change the front brake pads on a 1993 Aerostar. So the new pads fit, you need to squeeze the caliper back, and then tap out the slide rails. Remove the old pads and replace with new ones and reassemble.


Why would the brake system warning light and discharge warning light in the dashboard of a 1990 corolla turn on and how is this fixed Tried everything as the manual explained?

...I have the exact same problem with my 1993 corolla.......Brake System warning light and discharge warning light


What do you need to do if the rear brake caliper on a 1993 grand prix will turn but not compress?

Replace the caliper and bleed the brake system.

People also asked