answersLogoWhite

0


Best Answer

its fun, i just replaced mine 97 1500. replacing the dis. cap and broke the screws off, 70 $ at autozone for a new one, the hold down bolt is at 10 oclock under the cap, you cant see it you have to feel for it, its a 1/2 wrench it holds on a c clamp remove that you have to realy work hard to pull the dist. out, just remember to mark the firewall on the position of the rotor button so you dont get it 180 out when you put it back in, now the bad part when you get it all back together it will run, drive it to a shop and get it timed you cant do it with out a computer, the cam angle sensor has to be adjusted, need the computer to do that, it cost me 80 dollars

User Avatar

Wiki User

โˆ™ 2007-10-03 23:08:43
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How to replace a 1997 Dodge ram 1500 distributor?
Write your answer...
Submit
Related questions

Where is the 1997 dodge 1500 oil sending unit?

It is on the back of the engine, next to the distributor.


Where is the camshaft sensor located on a 1997 dodge 1500 pickup?

It is the "pick-up" plate in the distributor.


Where is the oil pressure sensor on 318 1997 dodge 1500?

Back of the engine, next to the distributor


How do you replace spark plug wires on 1997 Dodge Ram 1500?

Very carefully :)


What is a code P0320 on a 1997 dodge ram 1500?

Distributor speed sensor malfunction.Distributor speed sensor malfunction.


When is it recommended to replace the timing chain on a 1997 dodge 1500 5.2?

Whenever you rebuild the engine.


Have diagram of shift solenoid?

1997 dodge ram 1500 4x4 shift solenoid. where is it and how to replace?


How do you Replace cabin air filter on 1997 Dodge Ram 1500?

It doesn't have a cabin filter.


How do replace keyless entry on 1997 dodge ram p you?

I bought a 1997 dodge ram 1500 larmie and the seller lost the keyless enrty. who do i get a new keyless entry? will i have to reprogram/replace anything on the truck


Where is an oil pressure sending unit on a 1997 Dodge Ram 1500 4X4 5.2?

It is on th eback of the engine , next to the distributor.


Where is the oil pressure switch on a 1997 Dodge Ram 1500 with a 360 Magnum?

It is on the back of the engine, just to the passenger side of the distributor.


Where is an oil pressure sending unit on a 1997 Dodge Ram 1500 WITH A 360 MAGNUM?

1994 360 1500 is back by the Distributor cap, just to the front of it and on the passenger side


Where is the oil pressure sending unit on a 1997 Dodge Ram 1500 4wd?

It is on the back of the engine, next to the distributor.


1997 dodge ram 1500 5.0 engine block heater location?

1997 dodge ram 1500 2wd 1500 engine block heater location


Were is the camshaft position sensor located on a 1997 dodge ram 1500 5.9 magnum v8?

It is inside the distributor, called a pick up plate.


What is the firing order on distributor cap for a 1997 Dodge Ram 1500 v-6 changed timing gaer and did tune up but pulled pluges before marking them it is backfiring through carberatur?

what is the firing order for 1997 dodge ram v8


Egr valve location on 1997 Dodge 1500 pick up?

A 1997 Dodge Ram did not have EGR.


Where is the egr valve on 1997 5.9 mag dodge R-1500?

A 1997 Dodge Ram does not have EGR.


How do you change the camshaft sensor on a 1997 Dodge Caravan 3.0L or is it better to just replace the distributor completely?

I think you will have to replace the assembly, Not sure if cam sensor is available seperatly.


How do you remove a distributor cap from a 1997 Chevrolet 1500?

Very Carefully


Bolt pattern for a 1997 dodge ram 1500?

== ==


Does a 1997 Dodge van 1500 have a ballast resistor?

No.


How do you replace the water pump on a 1997 Dodge Ram 1500?

Drain the anti-freeze from the 1997 Dodge Ram 1500 cooling system. Remove the water return hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.


How much to replace deployed airbags 1997 dodge stratus?

How much should it cost to replace the airbags on a 1997 dodge stratus?


Is it possible to put a 2001 5.9 engine to replace 1997 5.9 lit Dodge engine for Dodge ram 1500 magnum?

Yes, although some of the sensors will need swapped.

Study guides

๐Ÿ““
Create a Study Guide