Want this question answered?
Probably need to replace the window regulator.
If its the back ones, take it to the dealer, there is a recall on that!
Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly
First you need to remove the door panel.Then remove the door handle bracket.Peel back the moisture shield.Tape the window into place,then unbolt the window from the regulator.Remove the window regulator from the access hole in the door.
You must remove door panel and replace window regulator.
You need to replace the power window regulator. Go to 1aauto.com and search for the video showing you how to do this.
remove back seat, remove screws bottom and top of panel, remove panel. remove 3 bolts and motor arm, window and regulator will pull out.
The window motor is attached to the window regulator by screws. After removing the door trim you must detach the regulator from the door by drilling-out four rivits. Then remove the screws from the old motor and install the new motor. Re-attach the regulator with bolts and put the trim back on the door.
You take the inner door panel off. Then, there is an arm that goes up and down called the window regulator. The glass is held in by hardware on the end of the regulator. If you get a used window from the salvage yard they will be able to tell you how to put it back in. Most of the time the window is separated from the regulator and the new window dropped in from the outside when the control handle is in the down position.
REmove the door panel and clip the cables on the regulator.Here's how to remove a door panelhttp://www.ricksfreeautorepairadvice.com/uncategorized/remove-a-door-trim-panel-from-any-vehicle%E2%80%94-without-a-diagramHere's how to replace the regulator and clip the cablehttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator
Depending on the year, 92 through 97. Yes! The motor is riveted to the regulator. You must remove as a unit, drill a hole in regulator arm and insert a bolt and nut to keep from springing back. Then drill out rivets to motor replace motor with bolts and remove bolt in regulator arm.
If the cable is off the pulley, the window regulator is toast. You may be able to get it back on, buy you're wasting your time. It will just come off again. Replace the entire regulator