.disconect negative battey terminal 2.raise vehicle. place on jack stands for safety 3.from under vehicle remove the starter brace 4.remove the wire harness from brace on transaxle bellhousing 5.remove the two bolts holding the starter. 6.lower slightly to gain access to the wires on the starter solenoid. disconnect electrial connectors from solenoid terminals. 7.remove from engine
NOT AT ALL
on the back of the engine . above the starter 10 mm bolt holds it in.
Depending on where a person lives and where they have the repair done, the labor for replacing the starter on a 2000 Saturn SL2 will cost between $186 and $238. The cost for the parts will be $149 to $261 plus tax.
2001 sl2. 119 exchanged NAPA auto parts
The water pump on a 1996 Saturn sl2 is located in the engine compartment. It sits below the AC compressor.
How do I replace the water pump in my 1994 Saturn SL2 series standard twin cam.
if it is anything like my 97' Saturn Sl2. The engine must be dropped out to dismount the transmission.
under the hood
Junkyard
Rear of the engine next to the firewall
Underneath the car. You will have to be able to get under the car to replace it. The starter, on any car I can think of, is always near the Flywheel. So underneath the car going into the Flywheel. One of the large battery Positive cables should be going to it.
starter is located on the firewall side of the engine. Access is easiest from underneath the car