If it is covered by carpet you may have to cut a "door" into it to get access to the light, some are pre cut. The whole bulb assembly is a white plastic framework holding all the bulbs. This has 3 or 4 clips protruding straight out that must be depressed inward towards the center simultaneously and the assembly will slide out. All the bulbs for that light are on that white plastic unit you have removed. Good luck.
i have oil in my water reservior in 02 volks passat
how can i replace a brakelight bulb on a 2002 nissan frontier?
How to remove the sun visor on a 2002 VW passat driver side
The light assy has to be removed to take the bulbs out.
how i found the change the oxygen sensor in 2002 vw passat
remove bulb from in side the boot
how do you replace brake-pads on vw beetle 2002?
Its a whole led unit replace whole deal not bulb
Take out the two screws and replace one or both of the lamps.
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
If you can't get to the back of the light through the trunk, you have to remove the light to change the bulb from the rear.
how to change a brake light on 2002 Nissan altima
brake light flashing on 2002 jetta tdi
fuse number 13 ,drivers side fuse box ck cover for fuse position haynes manual
You don't. Instead, you replace the entire assembly.
Peel the carpet from behind the light. You'll be looking at a white block with wires coming out of it. About midway down on either side there are tabs. Squeeze the tabs and pull.
The 2002 VW oxygen sensor is quite simple to replace. Remove the wiring harness. The oxygen sensor will simply pull out.
To replace front brake pads on a 2002 Ford Mustang safely raise and stabilize the vehicle. Remove the wheels and caliper. Slide out the front brake pads and replace with new units.
This site has step by step instructions (with photos), perhaps the A4 is similar. http://audidiy.blogspot.com/2010/04/how-to-replace-brake-light-bulb-on-audi.html
you push in front of lens into bumper, and than slide lens into bumper and it will pop out, then change bulb by pulling socket out.
open trunk look directly under light grab socket twist left and pull
need to find out how to replace a power brake booster in a 2002 Chevy silverado 2500 HD
brake light switch is above the brake pedal
How to replace fog light bulb for acura rl 2002
well i would ask for help and beg and hopfully get the money