Pontiac Grand Prix
Pontiac Sunbird
Grand Prix GT
Formula One
How To

How to replace front motor mount on 1991 Pontiac Grand Prix?

495051

Top Answer
User Avatar
Wiki User
2009-12-15 19:38:33
2009-12-15 19:38:33
Motor Mount
I assume you are talking about the top front mount. Simply slide a floor jack with a 2x3 under the oil plan. CAREFULLY raise the engine about an inch. The mount (commonly called a dog-bone) will unbolt and the new one will take it's place. Adujusting the jack with help you get the new mount lined up.




Dogbone says: See the related link below to see with pictures how I changed the lower one with pictures............Dogbone
1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

My grandson had to replace the motor mounts on his Pontiac Grand Prix last year and now the mechanic says they need replaced again. He has hardly driven it. How can that be

User Avatar

You will need to take out the whole motor to replace it. It is usually best to get a mechanic to take care of it.

User Avatar

How to reset the computer 1999 pontiac grand prix gt 3800 series II v6?

User Avatar

it's under the throttle body ,(air intake) on right side(back of the motor)pully and belts is on the leftside(front of motor)1999 grand am 3.4 sfi.

User Avatar

where can you find a diagram of 1994 pontiac grand am motor?

User Avatar

where is the location wiper motor Pontiac grand prix 2002

User Avatar

Are you talking about the oil pan reservoir at the bottom of your motor?

User Avatar

front of the motor bottom of the block on my 96

User Avatar

Where is the motor mount located on 1995 grand am

User Avatar

on 2.3l It is on the front of the motor under the intake manifold next to the starter.

User Avatar

The flex plate is bolted to the back of the crankshaft. It connects the motor to the torque converter in the transmission. To replace you remove the transmission and replace it.

User Avatar

yes it should bolt right up as well as the original motor and tranny

User Avatar

impossible i did and i had to drop the hole motor out of my car and so yah...

User Avatar

To replace the alternator you must tip the motor. by removing the motor mounts in front on the motor.just the two top ones and than roll the motor forward. that will give you enough room to remove the alternator

User Avatar

were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine

User Avatar

Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly

User Avatar

The blower rheostat on a 93 Pontiac Grand Am is located inside the engine bay, just to the right of the blower fan housing. It is almost directly behind the trans dipstick. It isn't that hard to replace.

User Avatar

http://www.a1electric.com/grandam.htm here is an excellent how to with pictures

User Avatar

Try this link, http://www.a1electric.com/grandam.htm. It shows how to replace the entire window regulator assembly (which includes the motor). Probably the cleanest description I have found.

User Avatar

Most radiators are located in the front of the motor, there should be a cap on one side or the other of it to add water.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.