answersLogoWhite
Clutches and Flywheels
Ford Ranger
Ford F-150
How To

How to replace the slave cylinder lines on a 1991 5.0 liter f150 ford?

272829

Top Answer
User Avatar
Wiki User
Answered 2005-09-04 20:59:21

you need to be more specific on year model there are a few different designs that all remove differently

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you replace a slave cylinder in a 96 chevey k1500


How do you replace the clutch slave cylinder on a 1989 jeep wrangler


How do you replace a slave cylinder on a 1995 dodge neon clutch


how to replace the slave cylinder on a 1993 jeep wrangler


HOW DO YOU REPLACE THE SLAVE CYLINDER ON A 1994 f 250 2 WHEEL DRIVE


to answer your question i need more info such as what type or model car is it and is it a clutch slave cylinder


Remove the transmission to excess the inturnal slave cylinder



The transmission has to be removed to gain access to the clutch slave cylinder.


if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.


The Slave Cylinder and the Master Cylinder control totally different systems. The Slave has to do with the clutch, and the Master has to do with the brakes. They have nothing in common.


The slave clutch cylinder on a 1994 Honda Civic is located inside the engine compartment. On the driver-side close the firewall. The clutch fluid should be drained. Remove the mounting bolts and clutch lines to replace the slave clutch cylinder.


No you don't have to drop the transmission in order to replace the slave cylinder, but be careful because it can easily be stripped.


You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.


It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.


I'm pretty sure that on that vehicle the slave cylinder is located inside the transmssion which means the transmission must be removed to replace it


The slave cylinder is usually replaced during a clutch replacement. The slave unit is fairly inexpensive but the labor can be costly since most vehicles require the transmission to be removed to replace the slave. Since the transmission has to be removed to replace the clutch anyway, there is no extra labor involved to replace the slave.


The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.


The slave cylinder for a manual transmission hydraulic clutch is inside the manual transmission bellhousing


You have to pull the tranny as it is located internally


To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.


first take off slave cylinder, it should be mounted on your frame, then take off hoses, connect hoses to new slave cylinder. mount slave cylinder back to frame and bleed ur clutch for f*****g hours.


remove 2 bolts holding it on,then replace, follow line back to bleeder valve,bleed,then bleed at slave cylinder


If the problem has been getting worse over time than it is your clutch. If was sudden, then it is your slave cylinder. Also, the slave cylinder will usuall leak fluid when it is bad. If your not sure and nobody else is either, replace the slave first. It is farely cheap and super easy to replace. I hope this helps and good luck!


Yo have to remove the transmission.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.