Chevy Suburban
Chevy Astro
Mitsubishi 3000 GT
Subaru Outback
How To

How to replace window regulator?

646566

Top Answer
User Avatar
Wiki User
2005-11-01 06:45:51
2005-11-01 06:45:51

Disconnect negative cable at battery. Remove the inside door trim panel, remove film watershield, remove the door window glass assembly by lowering the window all the way, remove inside door handle and rods, unplug electrical mirror and regulator wires, remove the glass stabilizer bolt, then the 2 window glass retainer bolts, lift out the window glass, then remove the 4 regulator assembly bolts and wiggle the regulator out thru the opening. Reassemble in reverse order. Buy a Haynes Repair Manual for about $15 and save yourself some anguish! YFC

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW

User Avatar

Driver Side Window Regulator Assembly replace on 2004 pontiac grand prix

User Avatar

how do I replace the passenger side window regulator on an E250, 2006. the window will not release to push to top of window frame only half way?

User Avatar

Window regulator controls the up and down motions of your car window. Both electric and manual windows have a window regulator. Not the easiest part to replace, but once you dissembled the door panel it should be fairly simple to replace.

User Avatar

To replace a rear window regulator on 2005 CTS Cadillac remove the side protection panel of the car door then adjust the regulator.

User Avatar

It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.

User Avatar

How to remove the window motor from the regulator

User Avatar

Replace defective window regulator

User Avatar

You must replace the entire regulator.Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator

User Avatar

How to replace a window and regulator on a 1998 checy malibu?

User Avatar

The way that replace a window regulator in a 2003 Buick LeSabre front drive side is by removing the door panel. Next, disconnect the electrical connector on the regulator and replace.

User Avatar

Can't be done. You must replace the entire window regulator.Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator

User Avatar

You will have to replace the complete window regulator assembly.

User Avatar

you need to replace the window regulator

User Avatar

Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.

User Avatar

You have to disconnect the glass from the regulator or clip the regulator cables.See this post for instructionshttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator

User Avatar

You have to disconnect the glass from the regulator or clip the regulator cables.Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator

User Avatar

Take the door panel off,you will need to remove 3 bolts for the window motor and then 3bolts(maybe4) that hold the regulator to the window

User Avatar

Must replace window regulatorhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator

User Avatar

The window is not off track. The window regulator is broken. In most cases you will have to replace the window motor and regulator as an assembly.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.