Pull the flasher handle towards you to toggle the brights on and off
The airbag computer has detected a malfunction and set a code.
Most likely the computer has detected a malfunction and set a code. Have the system checked for codes.
The computer detected a malfunction, set a code, and went into limp mode.
Usually all cars computers will re-set themselves (of trouble codes) after 50 or more start ups. As long as the problems have been repaired. Try disconnecting the battery for at least 10 minutes, that's what I always do for my Chrysler products. Best regards,& Good luck. Tony
I haven't had this happen to me, but it did happen to the previous owner of my '92 Grand Voyager. Chrysler had a warranty recall for this problem, and I'm fairly sure even though the brand Plymouth is now defunct, the warranty will still be honored. I'd call the nearest Chrysler/Dodge/Jeep dealership first, before you drive down to verify the warranty and to set up an appointment; they'll also probably need your vehicles VIN # to identify your vehicle.
If the clock/radio is anything like the one on the '93 Plymouth Voyager, here is how you set the clock: First turn on the radio, then press the set button. When it shows the "P" hit the select button, and it should change to just hours. Turn the Tuner knob to forward or back to set the time you want. Hit the Select button again to go to minutes, and do the same thing with the Tuner knob. Hitting the select button a third time will save the clock settings. ..
It is computer controled and not adjustable.
The crew of the Voyager do eventually get home. In the last fight with the Borg in "Endgame II" Janeway takes the voyager to Transwarp through the Borgs Transwarp hub. This is episode 172 and the stardate it is set on is 54973.4.
Grand Prix Construction Set happened in 1987.
Grand Prix Construction Set was created in 1987.
6 coin mint set 1994
Everything is set by the computer. If its not idleing right it is probably a throttle body sensor or a idle control sensor or a number of other things. You need to have it hooked up to the computer to check the codes.