I have a 2002 Grand Am SE- after I change the oil:) I have to turn ingition to on, but not all the way, just turn the electricity on in the car. press and release the gas pedal 5 times in a slow motion with a half second delay in between puishes., then turn off the car and turn it back on just like you would be to drive it. :)
How do you turn off the change oil light on a Chevysilverado 2002
turn the key forward to the on,but dont start it the press the gas petal 3 times and turn switch off the after that start it and see it that helps
what number is the fuse on a 2002 garnd cherokee and where is it located
You can change the light bulb by this method.
Turn ignition to ON position. Press brake pedal all the way down for 3-5 seconds. Pump the gas pedal 3 times quickly. Start the car. Oil change light should be off now. Works for 2002 Grand Am.
Turn ignition to ON position. Press brake pedal all the way down for about 3-5 seconds. Then pump gas pedal 3 times quickly. Start the car. Oil change light should go off. Works for 2002 Grand Am.
change the oil
With the car off, turn the key to the run position. Press the gas pedal to the floor 3 times . The car will chime and the Change Oil light will turn off.
assuming you mean the light bulbs, see the answer to "how do you change turn signal lamps both front and rear on a 96 mercury grand marquis" right here in WikiAnswers.
If Its an older Grand Marquis its easy. Find the knob that you pull out to turn on the headlights. Now, just turn it clockwise and the light will turn off!
You have to have the cause of the code that turned the light on repaired. The light will then turn itself off. You will need a scan tool to clear the code.
pictures of how to change front signal bulbs on a 2004 grand prix pontiac
Turn your key to on, but don't turn the engine on. Pump the gas peddle three times slow and steady under 10 seconds that is. And then turn on the car and the light should go out!
turn the key on and push the gas pedal to the floor 3 times in 5 seconds
AS MY WIFE SAYS : TURN ON THE IGNITION KEY (DO NOT START THE ENGINE) PRESS 3 TIMES THE GAS PEDAL THEN YOU WILL SEE THAT THE CHANGE OIL LIGHT STARTS FLASHING THEN TURN OFF THE IGNITION KEY.
turn the key in the on position without starting it and press down on the gas pedal three times and the change oil light should start blinking
The light is on do to a malfunction in the system. The problem will need to be fixed for the light to turn off.
After changing oil, turn key forward to accessory mode only press the gas pedal 3 times and remove key. Start vehicle as normal and light will clear the change oil indicator.
the socket should just turn out in the back under the hood.
If you mean the change engine oil light, and if your truck is like mine,then you turn the ignition key to the on position,(don't start truck), and step on the accelerator three times, then turn the key off. The light sould be gone after that.
If it is like other gm products....turn the ignition to the on position...depress the accelerator to the floor once per 1k miles you want the light to come on again..i.e. 5 presses to make it come on in 5000 miles.
You turn the car on to acc but don't crank the car, then hit the gas pedal three times and the light will start blinking then cut the car off then start the car up and it's off.
turn ignition switch to run do not start press gas pedal to floor three times within five seconds change oil light will flash if you did it rght turn off then start engine then you are done
Turn key on , do not start. Push gas pedal to the floor 3 times turn key off, then start engine.
Change the front turn signal light bulb. It's bad.