Fiat Punto
How To

How to you change the left head light bulb in a Fiat Punto?


Top Answer
User Avatar
Wiki User
2017-01-27 20:35:56
2017-01-27 20:35:56

Undo the unit retaining bolts(3)visible at front. undo spring clip holding headlamp (small cover) in place. Use a screwdriver to push the bulb holding spring to the outside of the car once unclipped pull it back to clear the plastic housing then pull down. Undoing the three bolts gives a bit more space.


Related Questions

Change the whole headlamp bulb. Should be a H4.

Orange light that looks light a light bulb

An amber bulb warning light in a Fiat indicates that a lightbulb check needs to be conducted. In this situation, checking the headlights, tail lights, and license plate lights would be advisable.

Access to the rear lights is gained from the inside of the car Pop out the two bungs on the upright, unscrew the two nuts located behind the bungs. Release the light unit, unclip the bulb holder, then replace the bulb.

how to replace brake light bulb fiat doblo van

Buy a bulb from Halfords, and get them to change it free....

Just changed mine it's simple just pop the bonnet and remove the retaining wires then take the appropriate bulb out and replace easy

it means one of your bulbs have gone for your exterior lights check all of them my back tail light was out and that warning ligh came on.

how to change light bulb light on the gear shift for a toyota matrix 2007

How do you change a fog light bulb on a 2004 VW Passat?

None. You vill change zee light bulb. Ve haf vays to MAKE you change zee light bulb!

go to the dealer i just cracked mine when trying to it never seen anything put together so shoddilly

hi how do you change aside light bulb on a skoda octavia

how do i change a parking light bulb on a 2003 hyunadi accent

how do you change a parking light bulb on a vauxhall astra 06 plate please.


how do you change a brake light bulb from a citroen c4 tail light unit. thanks

To change a light bulb for a fog light on a 1987 Trans AM, the engine must be switched off. Once the engine has been switched off the light bulb can then be changed.?æ

You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny

You wouldn't use a potato to screw in a light bulb... if the glass in the light bulb breaks as you're removing it, you can use a potato to take the light bulb out.

Remove the light bulb connector from the light. Take hold of the light bulb, push in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.

Look in the trunk, there is cover for the brake light, remove and you will have access to change the bulb.

how do you change the light bulb over the license plate on 2000 eclipse

how do you change the brake light bulb on a Peugeot 3008 Halfords cant figure out how to get access

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.