I found a Cold Air Intake kit at Advance Auto....
however it only fits up to 4" intake piping.
If the intake on the Vic is 4" it will work.
Id recommend getting a 4" HIGH FLOW filter from K&N....
make sure you get a high flow filter....a 4" Filter isn't very big for a 302....unless you can find a larger filter, with a 4" inlet that will fit....If not the 4" HIGH FLOW from K&N should work just fine...
but,
the intake kit i found was $100+, and the filter was $50
so its gonna cost you.
but nobody makes one, so the Universal kit at Advance Auto, is your best, if not, only bet.
Byzantium's Crown was created in 1987.
The cast of Crown Dick - 1987 includes: Peter Yoshida as Kim
Crown of Ancient Glory was created in 1987.
back side center of the intake, right up against the firewall, under the big silver intake plenum. Small hands and arms are a good thing. It has a hose running to it, but should slide out easily enough if you can get your hands on it.
On a 1987 Ford Crown Victoria : According to my Chilton's book : ( 20.0 U.S. gallons )
where is the fuel pump relay located on a 1987 ford ltd crown Victoria
According to my Chilton's Auto Repair Manual : For a 1987 Ford Crown Victoria : ( 20.0 U.S. gallons )
Bionic Six - 1987 Crown of the Scarab King 1-18 was released on: USA: 14 June 1987
DuckTales - 1987 Lost Crown of Genghis Khan 1-45 was released on: USA: 1 October 1987
The Lost Crown of Queen Anne was created in 1987.
That would probably be the intake maf sensor or intake air sensor, if it doesn't detect air flow it shuts off the fuel
Messy job, On the driver side you need to remove air intake assy and throttle assy to be able to remove the valve cover. On the passenger side, you have to remove the air intake plenum to get to the valve cover. Time consuming... but not impossible.