answersLogoWhite
Windows and Mirrors
Chevy Suburban
Door Panels and Handles

How would you remove and replace a rear passenger door on a 1997 Chevy Suburban K1500?

717273

Top Answer
User Avatar
Wiki User
Answered 2006-05-17 03:43:48

the door hinges are welded so you have to use a small hammer and small punch to tap out the pins that look like big nails.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


How do you replace a starter in a 1999 suburban


what kind of wrench to remove brake pads


how i can removefront headrest for chevy suburban 2001


The 97 Chevy Suburban doesn't have a timing belt.


Remove the wiring harness from your 2001 Chevy Suburban sub woofer. Remove the sub woofer retaining bolts. Reverse the process to install your new sub woofer.


what is the preceger for replacing the head gaskets on a 1993 chevy suburban 4x4 350


how do u replace passenger armrest on 2007 Chevy conversion van


Begin by removing the cover to your 1996 Chevy Suburban CD player. Remove the CD player retaining bolts. Remove the wiring harness from the back of the CD player. Reverse the process to install your new CD player.


If it has a 305/350 it will be on the front passenger side of the engine.


If you remove the headlight assembly you will have access to the turn signal bulb.


rear door-remove the door panel. back speaker carefully pry off grille cover and replace speaker


Removing a spare tire is easy to do from a Chevy Suburban. The tire is removed with the tool that is located on with your jack.


pull out the passenger side inner fenderwell. once out you can get to all the things needed to remove/replace.


No you can not. Theres no way to remove it from the top of the tank when the body is in the way.




how to remove fuel injector plug in on a 2007 chevy suburban 5.3



How do you remove and replace wiper switch on 2002 Chevy Cavalier


use a torch to melt out the plastic then remove the clips(on the inside) and remove as normal




The amplifier is located behind the passenger side glove box.


you remove the whell and then remove the bolts from the back of the calipier then remove the bolts from the monuting for the caliper then remove the rotor by pulling it off. if it is all one piece then you have to remove the hub itself




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.