answersLogoWhite

0


Best Answer

This question is about a 97 Pontiac Transport Van.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: I just had engine replaced now a clicking noise in engine and have to press accelerator too far to get it to accept gas and feels like loss of power steering when turning?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2000 Malibu steering clicking noise?

if clicking is in turns than a front axle needs replaced. if turning right it is your left axle-- turning left it is your right axle!! the clicking is the cv joint in axle.


Why after replaced power steering pump fluid blows out of fill cap?

IS the belt turning the power steering pump backwards


Why does my Steering wheel make a clicking noise when i turn it to the right when turning right?

The drive shaft may need to be tightened


Why does the steering on your 2003 z71 silverado truck lock up when turning right at very slow speeds?

The rack and pinion steering unit needs to be replaced


99 grand marquis creaking noise turning steering wheel?

Its your bushings, they need to be replaced. About $200 at a shop.


Why does power steering work turning to left but not right already replaced pump no difference?

The problem is your rack and pinion .


If you have a steering rack still hard to turn 1999 Taurus?

rack may be worn out and need to be replaced Power steering belt may be slipping and not turning pump fast enough Power steering pump may be bad


1994 Mercury Villager steering pops while turning right?

Sounds like a drive axle half shaft. Have it replaced. Not that expensive.


What causes a clicking sound when turning steering and the same sound when going over bumps on a laguna 1.9 2002?

sounds to me like a really bad c.v joint or joints


What could a loud squeak when turning the steering wheel on a 94 Toyota Paseo if the power steering fluid level is fine?

It probably means your power steering belt is loose or needs to be replaced. When you turn, the pump is under load and the belt is slipping on the pulley making a squeal.


How do you change a accelerator cable on a 95 lumina van?

The accelerator cable is connected with a swivel nut on each end of the cable. Loosen the swivel nut, by turning it to the left. The accelerator cable will come off. Reverse the process to install the new accelerator cable.


Why does your steering wheel make a noise when turning it?

power steering fluid not filled?