Antifreeze and Engine Coolant
Chevy Silverado
Pontiac Transport
Chevy Camaro Z28

I need to drain the engine coolant from the engine block on a 1997 transport. Where is the engine drain plug located?

131415

Top Answer
User Avatar
Wiki User
Answered
2008-05-12 02:47:28
2008-05-12 02:47:28

on the buttom of the block Can you please be more specific? Where exactly on the bottom of the block? Near what on the block?

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.

The coolant drain plug is located on bottom corner of radiator facing engine.

On front driver's side of engine block.

The 2002 Tacoma engine block will have two coolant drain plugs on each side of the block. The coolant drain plugs will be near the front and the rear of the engine block.

The engine coolant block on a Jeep Cherokee has two block coolant plugs. There is one on each side, next to the freeze plugs.

The water coolant on a BMW 525d is located in the radiator hoses, radiator and engine block. It is circulated via a pump which helps cool and maintain engine temperature.

Between the coolant hose and the engine block on the top driver side of the engine.

The MAF is located on the intake side of the engine, usually between the airfilter and the throttle body. The ECT (Engine coolant temp sensor) is usually located on the side of the engine block.

The coolant temperature sensor should be located near the upper coolant hose where it enters the engine block, just a few inches nearer to the windshield. It is usually a gold color.

The coolant drain plug on a Nissan Micra engine block is on the upper part of the block. It is under the intake manifold.

thermostat housing on the side of the engine block

The coolant gauge temp sensor is a one wire sensor located on the right rear of the engine block.

where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006

There is coolant in the engine block when the engine is not running. The engine block, heater, hoses and radiator remain full when engine is not running.

coolant temperature sensor are located where the coolant runs in the block near the thermostat housing normally the connector are on top of the sensor and the sensor itself screws in with a deep socket. The temperature sensor is usaully located where the coolant runs OUT of the engine close to thermostat housing.

It depends on what year you have. Some are in the back of the head and others are in the block where the block coolant drains are located. Some have one knock sensor and others have two.

should be located by the thermostat housing on front of engine block

Sometimes they use that threaded drain plug location to attach a knock sensor. So if you see a knock sensor threaded into the side of the block that may be where the coolant drain is located.

The 1994 Lincoln Town Car 4.6 liter engine coolant drain plugs can be found on each side of the engine block. There will be a total of four engine coolant drain plugs.

Open the drain valve on the side of the engine block.

The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.

The engine block coolant plug on a 6-cylinder is near the bottom of the engine. You will need to use a socket set and ratchet to remove the plug.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.