you need to remove the front right tire and the plastic shrowd in the wheel well you just pop out the plastic clips but don't break all of them or you can't put it back it back. The sensor is behind the harmonic balancer whichbis conected to the crank shaft or cam. You need to mark lines around the sensor there is not much room to work with since it is behind the HB. Remove the sensor and put the new one in and match it up with the marks you made so it matches the one you removed you want to match it as goodvas possible and that's it if you need pictures of what the harmonic balncer and cam position sensor looks like go to autozone.com and put the make and model in then look up the parts then go and look for the same on the car and do what I said people will tell you you need a tool to align the sensor correctly but if you mark it off and math it up really close you will be fine I have never heard of any problems when you do it with out the tool so Good Luck!!!!!!
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
Word the question properly. What is an Oldsmobile Royale?
this site is great
One at a time.
It takes a special tool. I got mine from Autozone and had a guide from them on how to replace it. You'll have to remove the belt and harmonic balancer and access it through the passanger side front tire.
5 quarts if you remove and replace filter.
first thing to replace would be the flasher can
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
If your car is that old and you aren't trying to restore it for a collection you probably should get a new car
Inside the fuel tank. The tank has to be removed and the fuel sending unit removed to replace the fuel pump.