Car Starting Problems
Buick Regal

I replace a ignition switch on 1995 Buick regal with a key chip and still won't start and security light comes on?

123

Top Answer
User Avatar
Wiki User
Answered
2009-10-01 13:51:15
2009-10-01 13:51:15

i replaced the steering colomn in 95 Buick regal and now it wont even turn over.does the different key that i got with the colomn have any thing to do with it not starting.?

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Replace ignition switch for 1993 buick century?



how do you replace a ignitionswitch tumbler 1991 buick skylark


http://www.automotivehelper.com/topic1054152.htm or Goole "ignition switch replacement 2001 regal"


turn ignition on leave it on for 10 minutes then switch ignition off then you start the car


The best answer is.....................take it to a Locksmith.........this is not a job for a wantabe mechanic (or locksmith lol ;-). TommyTrouble


how to replace window toggle switch 1999 buick century


yes u can all u need to do is go to a car store and buy the parts that you need for the ignition switch and put it in and it shud work i am a son of a machanic.


Why is my security light on and will not let my key come out of the ignition. 1999 buick regal



I believe that the switch is located in the ignition cylinder (which you can get from any auto parts store). Unfortunately you'll need a steering wheel puller and a tilt removal mechanism before you can start with that.


I have the same problem with my 1989. The best I have found so far is this: http://wiki.answers.com/Q/How_do_you_change_an_ignition_Switch_on_a_90_Buick_Century


A ton of Buick and GM owners replace the ignition switch so that their cars won't cut out and KILL THEM.


fuel pump keeps running after the key is out what do I need to check I have to remove the fuses to stop the pump.


It is quite simple to replace the turn signal switch on your 1990 Buick LeSabre. The turn signal switch simply plugs in and out.





My experience with a faulty ignition switch on this generation Regal include random warning lights coming on together and turning off at the same time. Eventually, the car will sometimes stall when the turn signal switch is used. This is due to the turn signal switch "bumping" the wires leading into the ignition switch. Apparently, the wire connections inside the ignition switch sometimes tend to loosen. Dealer cost runs around $350 to $400 to replace.


If all other electronics in the car work (lights, dash, radio, etc.) but the car wont start and the security light is flashing, take your key, put it into the ignition, turn it to the on position, and wait a FULL ten minutes before attempting to start the car. If this does not work, try again. If it still does not work, then you will need to take the car to a dealership and have them replace the ignition switch and replace the key (cost: about 200$). If you don't care about the security system, you can buy a transistor at radioshack for about 2$ and have someone who knows what they are doing solder it to the ignition wires to permanently disable the security system.



Do you mean the main switch by the driver or the switch on the door itself?


Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.


On top of the lower portion on the steering column.


replace the combination switch on the turn signal stalk



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.