Want this question answered?
A standard oscilloscope is designed to measure voltage, you need a current probe for your oscilloscope to measure current.
Oscilloscopes only measure voltage over time. Current cannot be measured with an Oscilloscope directly, but can be measured indirectly. Measure the voltage across a known load and calculate the current.
maximum and or minimum peak of any signal measured on an oscilloscope
An oscilloscope is the machine, but it measures frequency.... so sound waves are measured by frequency
Usually with an oscilloscope which shows a graph of the voltage, and then the peak-to-peak ripple voltage can be read off the screen.
When a signal of 10 mV at 75 MHz is to be measured then which of the following instrument can be used -
IT DEPENDS WHAT MEASURING INSTRUMENT YOU ARE USING. RMS - IF USING THE CLAMP AMMETER OR PANEL METER OSCILLOSCOPE - BOTH CAN BE READ
Since there are several kinds of waves, there are several ways to measure their frequency. Electrical waves can be measured with a frequency counter, an analog frequency meter or an oscilloscope. Ocean waves' frequency is measured with a stopwatch, but most people who measure ocean waves want to know how large they are rather than how fast they're coming.
reserve capacity  noun Automotive .the capacity of a battery, measured in minutes, to keep a vehicleoperating if the charging system fails.
This is most easily done using an oscilloscope with a current probe. Also phase angle must be measured relative to something else, usually the AC voltage at one end or the other of the branch of the circuit where the current is being measured.
Caliber is the size across the pin of a bullet in inches. So a .50 caliber is five tenths of an inch. From future automotive engineer A. Mike
In order to find out the loudness of sound waves, an oscilloscope can be used. Oscilloscopes demonstrate sound wave patterns, but it must be hooked up to a microphone in order for it to be heard.ADDED: It is measured directly and quite accurately by sound-level meters, and these are used by environmental-monitoring specialists etc..You can use an oscilloscope, but not directly. That shows the sound's wave-shape as a voltage analogue, so to calculate the sound level itself from the display on the screen, you also need to know the sensitivity of the microphone and the gain of any amplifier. If you want to determine the sound's full characteristics, replace the oscilloscope by a spectrum-analyser.