Cars & Vehicles
Lincoln Town Car
Oldsmobile Intrigue

If cruise control on a 1997 Town Car does not work and when pushing the on button then pushing setaccell the indicator light on the dash comes on what is wrong?

121314

Top Answer
User Avatar
Wiki User
2008-03-26 18:49:58
2008-03-26 18:49:58

You need to have the Cruise Control Module recall work done on that car. It's free at any Ford, Lincoln or Mercury dealership. It can cause a fire. The fact that your's is not working is an indication of hazard. Take it now!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

TCS stands for Traction Control System. Pushing the button turns the traction control off.

User Avatar

1. Select "oil life" with the display button, by pushing in till it comes up. 2. Push the button again and hold 10 seconds. 3. Let off the button and push again and hold for 5 seconds. Indicator should return to 100%.

User Avatar

When the red sleeve shows in the window, the air filter is clogged. the indicator is connected to the engine side of the air filter, and the increase in vaccum causes the indicator to trip. It can be reset by pushing in the button on the end.

User Avatar

Try pushing the two buttons on the right side at the same time (The "start" button and the "reset" button). If that doesn't work, then try pushing the two buttons on the bottom half of the watch (the bottom right button--"reset"-- and the bottom left button--"mode"). On my xhilaration watch, the two buttons on the right side control the daily alarm while the two buttons on the bottom half control the hourly chime.

User Avatar

Unlocks Emo Crys: Up (+Control Pad), Up (+Control Pad), Left (+Control Pad), Left (+Control Pad), Down (+Control Pad), Down (+Control Pad), Right (+Control Pad), Right Unlocks Jay Jay: L Button, R Button, A Button, Left (+Control Pad), Right (+Control Pad), Y Button, R Button, L Button Unlocks Lil' Rob: L Button, Left (+Control Pad), Y Button, R Button, Right (+Control Pad), A Button, Up (+Control Pad), X Button Unlocks Spitbal: Up (+Control Pad), Up (+Control Pad), Down (+Control Pad), Down (+Control Pad), L Button, R Button, L Button, R Button Unlocks Jack Knife: X Button, A Button, X Button, Y Button, Up (+Control Pad), Left (+Control Pad), Down (+Control Pad), Right (+Control Pad) From wwwgamefaqcom

User Avatar

Threre is a button just a little below the 'shift' button on the gearshift. Pushing this button in will turn off o/d. Threre is a button just a little below the 'shift' button on the gearshift. Pushing this button in will turn off o/d.

User Avatar

This means the Traction Control System has kicked on. Your wheels lost traction and it has actived. You can turn your TCS off by hitting the button and then it will stay lite. The Acura automatically resets this system to ON whenever you start your car so to turn it off you will have to keep pushing the button to off. TCS is great when the roads are slippery so I wouldn't turn it off then.

User Avatar

Turn ignition on, go to where it says service exceeded. Hold in the reset button for about 4/5 seconds till it says Do you want to reset the interval, then press and hold the reset button again until a signal sounds. The reset button is behind the indicator an cruise control stalks on the dash (black pointy button). Its in manual on page295

User Avatar

There is a button on top of the indicator, Just push it down.

User Avatar

When mine did that, I tried pushing on it a bit and pressing on it while pushing the button.

User Avatar

There are some automatic gear buttons. You can change them by pushing or pulling the handle of the gear forward or backward next to the correct button.

User Avatar

Pushing the power button on the computer

User Avatar

pushing the button, it's very hard.........

User Avatar

push the menu button and a clock symbol will appear. push the button under the clock symbol and hr and mn words will appear. pushing the button under the hr will change the hour and pushing the button under the mn will change the minutes.

User Avatar

It means the traction control system is turned off. Turn it back on by pushing the button marked TCS.

User Avatar

Check for power to the reset button in and out when reset-

User Avatar

Pushing the button on your remote....

User Avatar

Pushing the "OFF" button, and the "WARM" buttons TOGETHER, will read the codes. Pushing the "OFF" and "HI" buttons TOGETHER to clear codes. Assumingthe cause of the light initially to come on, was corrected, the light should go off. Good luck

User Avatar

The channel that NESN is on with Time Warner Cable will vary depending on location. You can access the channel guide on the remote control by pushing the guide button.

User Avatar

hi the l3 button is pushing the left anolog stick in u will hear a click

User Avatar

You have to hold the walk button, while pushing up on the d-pad and pressing the jump button.

User Avatar

When the service indicator light is illuminated, hold down the scroll button. The service display will return to 100 percent and the indicator light will off.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.