I have 33x12.5 on my truck and a three inch body lift
All you need to do is purchase a life kit designed for that truck. A lift can be put on by a friend that is a mechanic or by a repair shop.
you'll need to get a lift kit of about 3 inches and that's it
It is when you put a lift kit only on the front end of your truck or SUV.
yes
no you dont need a lift kitt to put 20s on a caprice you can put 22s on it without a lift kitt
It depends how you want to lift it, physically possible but hard, but you can buy a jack and put some suspenders under the truck and lower the jack, the suspenders will keep the truck lifted.
Normally a suspension lift kit levels the truck's nose with the rear. It may depend on the type of lift, but that's normally the case.
If you have the keys, turn the switch forward to the "run" position press the brake pedal down and put the truck into neutral. If you are using a tow truck with a lift on it with NO keys, lift from the rear that is if it's not a 4 wheel drive.
Snowmobiles only need a lift if they need to be worked on. If you need to put a new engine into your snowmobile you would need to have a lift to be able to get under it and work. If you need to check your traction same goes for needing a lift to look under it.
He has a red Ford F.250 But he wants to put a lift kit on it.
You must properly block wheels that are not being lifted. Use a jack to lift, and a jack stand to secure. Use common sense (make sure vehicle is on level surface, don't put body parts under, etc.).
first you need to find all the bolts that hold the body to thechassis. measure how big the bolts are and go out and buy hockey pucks. the # of hockey pucks you buy will depend on how much you want to lift the truck (about one hockey puck per inch lifted) lets say you have 12 bolts... you will then have to buy 12 hockey pucks for every inch you want to lift the truck. i would suggest you don't lift it any more than 2-3 inches. if you go any higher you will have to extend all the electrical wires and shocks and that ruins the point in a cheap lift. drill a hole in the hockey puck the size of the bolt and put the bolt through it and put it back on the truck just like it was but now it is spaced out by the hockey pucks. you now have a good lift. good luck and be safe man.