Auto Parts and Repairs
Ford Ranger XLT
Grand Am GT

If the ABS light on a 1996 Grand Am GT is on but the ABS works how do you turn off the light?

545556

Top Answer
User Avatar
Wiki User
2005-10-05 15:39:41
2005-10-05 15:39:41

The light is on because there is a problem with the system. You turn it off by having the problem corrected. Are you sure the ABS is working? Your normal braking system will work even if the ABS does not. I suggest you take this to a professional for repair.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Replace the bulb it works when you turn on the driving lights and when you brake. there are two little springs inside the light one is for the brake light and the other is for the driving light. All you need to do is replace the bulb. good luck.

User Avatar

Fix the ABS so it works. Unhook the battery for 5 minutes.

User Avatar

If Its an older Grand Marquis its easy. Find the knob that you pull out to turn on the headlights. Now, just turn it clockwise and the light will turn off!

User Avatar

The light is on do to a malfunction in the system. The problem will need to be fixed for the light to turn off.

User Avatar

Probably a bad bulb They are double filamented with the smaller filament for stop and turn Larger is for tail light

User Avatar

How to reset or turn off the VTD-Cranking signal on a 1996 Pontiac Grand Am SE 2.4 Twin Cams

User Avatar

If a turn signal does not blink on a 1996 Honda Accord that it is time for it to be changed. To change the bulb and locate the light housing and remove the older light. Replace the light.

User Avatar

Under the dash on the drivers side; Turn on the turn signal (if it works) and follow the clicking sound.

User Avatar

When you turn the key off and lock the doors, there will be a red light on the top of the dash that flashes while the alarm arms.

User Avatar

Sometimes my sons 2001 Grand Am does that. It has to do with the Security System. Turn the key to ACC the Security light will start blinking and will continue to do so for 10 minutes. At that time the Security Light will stay on. At that point you can start you car. This works for him Good Luck.

User Avatar

Turn the key to the on position, wait ten minutes, then it will turn over.

User Avatar

Turn ignition to ON position. Press brake pedal all the way down for about 3-5 seconds. Then pump gas pedal 3 times quickly. Start the car. Oil change light should go off. Works for 2002 Grand Am.

User Avatar

On a 1996 Mercury Grand Marquis the windshield washer squirter button is on the end of the turn signal lever

User Avatar

The turn signal light can be accessed from the back of the turn signal light assembly. Push the lightbulb connector in and turn at the same time. The lightbulb will come out and can be changed.

User Avatar

Turn ignition to ON position. Press brake pedal all the way down for 3-5 seconds. Pump the gas pedal 3 times quickly. Start the car. Oil change light should be off now. Works for 2002 Grand Am.

User Avatar

You can turn the traction control on and off. If the light is on, then it is turned off or there is a problem. Read your owner's manual.

User Avatar

I have a 2004 grand prix and the fog light switch is on the turn signal lever. It's located around the middle of the lever and you turn and release it. A green indicator light will come on in your gauge cluster telling you they are on.

User Avatar

you just hold the head light stick turn it clockwise one turn and then puul it to out side

User Avatar

Simply turn on your engine, then momentarily press select button display followed by holding down the set button

User Avatar

You put the key in the driver door and turn to the unlock position.

User Avatar

check your crankshaft sensor or the auto shutdown relay

User Avatar

I know for my grand am, I have to leave my key in the ignition for 15 minutes.

User Avatar

Are your lights automatic or do you have to turn them on??? If there automatic then you need to turn the knob to the left of the steering wheel and turn it to "Off" and its the same if there not automatic too.

User Avatar

1996 jeep grand Cherokee makes loud clicking noise when turning steering left


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.