Auto Parts and Repairs
Starters and Ignition Systems
Ford Expedition Eddie Bauer
Ford Expedition XLT

If the starter of an 1988 Aerostar will not shut off but does stop running when the key is off is this the relay or what?

373839

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:12:45
2015-07-15 19:12:45

bad soilinoid on starter

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Mounted to the top of the starter

The starter relay is on the driver's side fender behind the battery.

Where is a starter realy located on a dodge ram van

The starter relay operates the starter soleniod. The relay is located on the firewall at about the 8 O'Clock position looking at the brake booster. It has 4 wires in one connector going to it.

The starter relay is located inside the engine compartment, on the left/passenger side wall (to left of the firewall) attached by one screw to the wall.

where is the starter relay located on a 1990 Lincoln mark 7

The starter solenoid is not disengaging once engine is started. Rebuild starter or replace with a new starter.

It is behind the mud cover in front of the rear wheel

The relay, also called the starter solinoid, is bolted to the frame right next to the battery. Just follow your battery cables and they will lead you to a small round piece of plastic with three metal posts sticking out of it. This is the relay.

It might be due to a dead battery or to a poor cable connection to the battery.

Change a starter on a 1988 Toyota Cressida

On my 93 Shadow, the Auto S/D relay is on the driver side just outboard of the battery. It is located under the lip of the front left fender separate from the A/C and Starter relay which are side by side).

I have changed the starter relay at least 10 times. FinaLLY CHANGED THE STARTER> WORKED FOR AWHILE then the relay started sticking again and burned up another starter. First I thought it was residual magnetism keeping the coil in the relay energized. Then, contacted car quest about possible bad relays. Disconnected all voltage from relay, ignition and battery. The contacts were still in the closed position energizing the starter when positive from the battery was connected to the relay, no voltage from ignition, wire off. I suspect now the starter is pulling so much current it is melting the contacts together . So far I have not came up with a solution. Driving me nuts!!! The definition of insanity is doing the same thing over and over and expecting change. Sounds like you need a professional diagnosis.

The starter on a 1988 Chevy Celebrity is located on the bottom of the block at the bellhousing.

Relay of Youth ended in 1988.

a soleniod is just one item in a schematic its like a big relay if it needs to be replace its like 8 bucks, if you want the schematic for the whole starter system its basically battery+ to soleniod to starter to battery-

Yes, It should be an Aerostar.

You can find your 1988 Acura Integra starter on the right hand side of the engine. You can follow the positive battery cable directly to the starter.

That would depend entirely on which relay you are referring to.

you can disconnect the starter relay and run a wire from the starter wire in the connector to the power wire on it p.s. it is easyer to take a curcit tester and probe the connectors with someone truning the ignition switch to fine the starter the starter wire is brown and im not sure about the power lead from the ignition switch

Where can I find a free starter solenoid replacement diagram for 1988 ford f250

Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

Through 1988, the tank size is 17 gallons.

You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.