I had a similar problem on my Mitsubishi Galant when I bought new Mags. It seems that a plastic bushing is needed on the HUB to center the wheel. This happens, sometimes, with after market wheels. Hope this helps. bad tires or improper tire balance could cause wobbling.
how do you replace the front rotors on Toyota Land Cruiser
how do i remove the brake rotors for a 2003 Toyota tacoma v6 2wd
There will be a pulsating on braking.
as long is they are not dug into the rotor its normal after driving to get lines or marks on the rotors and drums
Warped rotors. Driving using the left foot to brake causes the rotors to heat up. Quenching the hot rotors by driving thru water will cause them to warp. The warped rotors cause the pedal to pulsate.
Yes, you are correct.
take it to the dealer
I have replaced the front disc brake rotors, pads and the rear drums and shoes with new components on my 1994 Toyota Celica ST. The auto transmission is operating well. What could be making a rotational noise?
When changing the brake rotors on a 1990 Toyota 4runner the vehicle must be safely raised and propped up. The calipers must be loosen and rotors will be able to be removed. The process must be repeated for all four wheels.
calipers may not be depressing all the way , causing the brakes to drag and heat up rotors causing them to warp + another possibility is tightening down the rotor TOO tight onto the hub- or - not having it turned and rubbing uneven- good idea to turn the rotors onn each brake change if you have been just leaving the rotors on- and changing pads- this may be the issue- 2dynamic
200
Most IS 250s, depending on driving, get about 25000-30000 miles on the front brakes and rotors.