0
False. If the gas pedal becomes jammed slip the shift into neutral, pull over when safe to do so, park the vehicle, shut the engine off then call for a tow truck or a mechanic.
Wiki User
∙ 6y ago
Add your answer:
Earn +20 pts
If the gas pedal becomes jammed press hard on the gas pedal?
False. If the gas pedal becomes jammed slip the shift into neutral, pull over when safe to do so, park the vehicle, shut the engine off then call for a tow truck or a mechanic.
If the gas pedal becomes jammed should you press hard on the gas pedal?
False. If the gas pedal becomes jammed slip the shift into neutral, pull over when safe to do so, park the vehicle, shut the engine off then call for a tow truck or a mechanic.
What if the Gas pedal becomes jammed do you press hard on the gas pedal?
Slip the shift into neutral immediately, pull over when it is safe to do so, put the vehicle in park and shut the engine off.
Why 1990 Geo Tracker brake pedal hard to press?
Hardness in the brake pedal can because by low brake fluid. Air in the brake lines can also cause the pedal to push hard.
Why your brake pedal feel hard to press?
The power brake booster is failing.
What causes hard brake pedal in VW beetle?
Any time the brake pedal is hard to press then you need to check and see if the brake booster is functioning properly.
What are the affects of a bad fuel pump?
when you press your gas pedal hard and your car stalling on the high way
What could be the problem with a c 230 kompressor when the gas pedal becomes hard to press to get up speed?
The only time I have encountered stiff gas pedal was either a) the ASR switch was engaged (the caution light comes on the dash if engaged)when slippery conditions exist or b)the cruise control is engaged thus limiting the freedom of travel at the gas pedal.
Why would it be Hard to shift craftsman lawn tractor model 917.270514?
Either the drive belt is not releasing far enough when you press the clutch pedal or the brake is not engaging enough. You will need to see if the belt is still turning when you press the clutch pedal down.
How do you check a hydraulic brake servo?
With the engine off, press hard on the brake pedal. Turn the engine on and the pedal should depress slightly but no more than an inch or two. If your brakes either drag or stick on, or sometimes the pedal goes real hard under foot it means your servo is shot!
Why does the brake light come on when you touch the pedal and go out when you release the pedal on a 1990 jaguar XJ6 The brake pedal is hard it has brakes but you have to press the pedal down hard?
if the brake pedal is hard you might first want to check if the mineral oil is full, get the castrol mineral oil for jaguars with the attached pump. Make sure the oil level is green with a black dot, if is clear with a black dot then the container is empty and it needs oil.,, Good luck bud..!!
How do you fix it when I press the brake pedal the brake lights flash but do not stay steady until the brake pedal is pushed down hard on a 1989 Grand Marquis?
Adjust or replace the stoplight switch at the upper end of the brake pedal under dash area
